Garage cleanout

4gpwr · Post by **4gpwr** » Fri May 23, 2008 6:34 pm

I am doing a garage cleanout mild steel 3 inch dump for a tco6 Starion exh housing $50 Original exhaust manifold no cracks $200 Adaptor flange for starion exhaust manifold to a t28 turbo cost a bit to make $150 Working order map sensor$100 Working order dash cluster $150 Pick up only

Nosaki Faki · Post by **Nosaki Faki** » Fri May 23, 2008 10:13 pm

will it fit a factory US TD05?

Lunacy · Post by **Lunacy** » Sat May 24, 2008 7:26 am

Got a pic?

4gpwr · Post by **4gpwr** » Sat May 24, 2008 1:16 pm

Nosaki Faki wrote:will it fit a factory US TD05?

TC and TD are a diffrent era of turbos

Nosaki Faki · Post by **Nosaki Faki** » Sun May 25, 2008 8:32 pm

It appears to be the same as the TC05 that is on it now, it has 2 separate round flanges but the one for the wastegate is capped.
Is that how they are normally or is mine different?

Nosaki Faki · Post by **Nosaki Faki** » Sun May 25, 2008 8:57 pm

Like this.

[/img]

4gpwr · Post by **4gpwr** » Mon May 26, 2008 9:29 am

I am sorry i cant transfer photos it looks like the right flange off the turbo but the center bolt is at the top of the three bolt flange cant say for sure

redzone · Post by **redzone** » Mon May 26, 2008 12:23 pm

yep the dump pipe SHOULD fit as the yank TD05 ex housings are same shape as our TC06's TC05's etc

4gpwr · Post by **4gpwr** » Mon May 26, 2008 3:25 pm

Just suspect the Flange is not on right angle

Nosaki Faki · Post by **Nosaki Faki** » Tue May 27, 2008 9:33 pm

I will take it and give it a go if you're willing to chuck it in the mail?
I'm a fitter & turner so I can mod it easily enough if need be I just don't have access to all the gear I need to make my own nowadays.

redzone · Post by **redzone** » Tue May 27, 2008 9:37 pm

i just checked my widey and the 3 bolt flange has the top bolt right at the top..

Nosaki Faki · Post by **Nosaki Faki** » Tue May 27, 2008 9:42 pm

so at worst I would need to cut and re-weld it.

Yes/No.

4gpwr · Post by **4gpwr** » Thu May 29, 2008 4:44 pm

Nosaki Faki wrote:so at worst I would need to cut and re-weld it.

Yes/No.

Not going to post office for $50 next time you come to melb contact

flav · Post by **flav** » Sat May 31, 2008 4:36 am

Yer, they bolt up differently...but mods can be done

4gpwr · Post by **4gpwr** » Sat May 31, 2008 5:22 pm

[quote="4gpwr"][quote="Nosaki Faki"]so at worst I would need to cut and re-weld it.

Cant cut the flange and reposition it because the 3 inch 90 deg pipe has been dinted to clear bolts

Austarion

Garage cleanout

Garage cleanout

dump

dump

Dump

Re: Dump

Who is online