I currently have one in stock.
These are bolt on top portions of the thermostat housing that will route the rear water neck off a 4g63 dohc head parallel with the back of the head instead of pointing out into the firewall.
Taking paypal. 40 shipped via usps air
Here is a pic of what it would look like installed.
http://b18c5.org/eric/bmw/bmw101.jpg
dohc conversion 90 degree thermostat housings fs
-
- Enthusiast
- Posts: 737
- Joined: Wed Feb 02, 2005 2:46 pm
- Location: oregon, USA
- Contact:
dohc conversion 90 degree thermostat housings fs
Last edited by airbats801 on Tue Oct 16, 2007 5:01 pm, edited 3 times in total.
'78 Colt cp, 80 challenger "scorpion" 5spd g54bt conversion almost complete, '80 plymtouh arrow "might max" , '90 mitsu terror van "spacewagon"
80's Hero
80's Hero
-
- Enthusiast
- Posts: 737
- Joined: Wed Feb 02, 2005 2:46 pm
- Location: oregon, USA
- Contact:
-
- Enthusiast
- Posts: 737
- Joined: Wed Feb 02, 2005 2:46 pm
- Location: oregon, USA
- Contact:
-
- Enthusiast
- Posts: 737
- Joined: Wed Feb 02, 2005 2:46 pm
- Location: oregon, USA
- Contact:
I havent tried one personally, but from test fitting compared to a stock dohc one. The only massaging would be the main housing coming out of the head. Basically, instead of the water neck pointing out about 30 degrees, it runs straight along the back of the valve cover. So there is definately less banging needed, if any at all? I think you still need to bang a little for the cas?
'78 Colt cp, 80 challenger "scorpion" 5spd g54bt conversion almost complete, '80 plymtouh arrow "might max" , '90 mitsu terror van "spacewagon"
80's Hero
80's Hero
-
- Enthusiast
- Posts: 737
- Joined: Wed Feb 02, 2005 2:46 pm
- Location: oregon, USA
- Contact:
Who is online
Users browsing this forum: No registered users and 24 guests