Page 1 of 1
If you ever need an engine hoist....
Posted: Wed May 31, 2006 8:41 pm
by Glen GSR III
Excavators work quite well. :D
out ere in da bush we do fings diffently :roll:
dig
Posted: Wed May 31, 2006 10:54 pm
by Starion VR4
mmmmm, glen very insteresting, do U have adump truck as well? I need a pool dug at my place, think we could work something out?
:beer :beer
Posted: Thu Jun 01, 2006 6:28 pm
by JD_Stazza_Brendan
afterwards did you go drink some green cans down by the river bed
Posted: Thu Jun 01, 2006 6:32 pm
by Glen GSR III
ur just jealous
:D
Posted: Thu Jun 01, 2006 6:39 pm
by MrBishi
I've done the same thing with a mini bobcat. Sure beats busting your arse.
Posted: Thu Jun 01, 2006 8:35 pm
by Mick
glen and mrbishi, good luck with the 4g63 excavator conversions... :beer
Posted: Fri Jun 02, 2006 2:42 pm
by chunkhead
I've changed tyres with a forklift! Not on the Staz though! :D
Posted: Fri Jun 02, 2006 9:05 pm
by SIR GSR
Glen, good to see that the Ippy boys still like to get dirty with their cars ;)
Posted: Sat Jun 03, 2006 9:33 am
by Glen GSR III
As always mate :)
Anyone notice i've got an engine fan instead of twin thermos???
Posted: Sat Jun 03, 2006 1:12 pm
by fr335tyl3r
Yeh I did notice that :P
Posted: Sat Jun 03, 2006 1:58 pm
by jrod82
Glen GSR III wrote:Anyone notice i've got an engine fan instead of twin thermos???
That's cos it's a GSR.
Posted: Sat Jun 03, 2006 6:08 pm
by ProZac
Glen GSR III wrote:As always mate :)
Anyone notice i've got an engine fan instead of twin thermos???
Its an import thing.
Posted: Sun Jun 04, 2006 11:35 pm
by redzone
hey there are plenty of FORKLIFTS getting around with 4G63`s!!!!!!!!!!!!
p.s. glen what brand front spoiler is that on the excavator??
Posted: Mon Jun 05, 2006 8:18 am
by Glen GSR III
Its the new MMC top secret rally air dam.
Its been said Mitsubishi sacirificed speed for its super strong design
Basically because you've got no hope of winning you just trying and fuck everyone elses chances too.
Posted: Mon Jun 05, 2006 10:01 am
by mitch
ive seen a few new crown forklifts with mitsubishi engines in them that look like a 4g6 but dont know the capacity. Anyone know for sure?