Austarion

Still a little ways to go the outside:
http://www.fr33z3.net/starions/new_001.jpg
http://www.fr33z3.net/starions/new_005.jpg

A couple of seats and a rollcage should see the inside finished:
http://www.fr33z3.net/starions/new_019.jpg

And almost done here too:
http://www.fr33z3.net/starions/engine_assembly5b.jpg
http://www.fr33z3.net/starions/engine_assembly5e.jpg

Should end up something like this:

:)

Cheers
Jeff

LOL

but hey, that engine looks clean!!

I see you've got your priorities in order, a slab of Coldies up front ;)

JJH wrote: A couple of seats and a rollcage should see the inside finished:
Cheers
Jeff

are you making your own cage jeff ?
I've just ordered tube to do the cage have to pick up on monday or tuesday from Bayswater
my staz which is gutted and near ready for bar work
although I still to have tar to remove from the floor

cheater

Cheater,
No quite kitted out to do my own cage, which is probably a good thing. :D

I have had discussions with Brown-Davis in Bayswater to fit a fully welded job.
My main issue is that I want to ensure the roadworthiness of the car with the cage fitted, as I want to try and do events like the Mt Buller sprint and other road rallies.
Cheers
Jeff

Bond Roll Bars in Sydney make CAMS approved bolt in cages for the Starion. They come in kit form, ship Australia Wide.

Bond Roll Bars
22 Carlingford St Regents Park NSW 2143
ph: (02) 9743 7005

Thanks Cookie, I'll give them a call.
Cheers
Jeff

JJH wrote:Cheater,
No quite kitted out to do my own cage, which is probably a good thing. :D

I have had discussions with Brown-Davis in Bayswater to fit a fully welded job.
My main issue is that I want to ensure the roadworthiness of the car with the cage fitted, as I want to try and do events like the Mt Buller sprint and other road rallies.
Cheers
Jeff

Brown-Davis is where I have to pick up tube from ,they seamed helpfull

cheater