87 Conquest Revention

Display your ride and post power figures, dyno runs, drag and circuit times.
Post Reply
C89ZX7R
[P] Plates
Posts: 36
Joined: Fri Jul 16, 2004 6:23 pm
Location: USA

87 Conquest Revention

Post by C89ZX7R »

What it looked like before it was recycled :D

http://www.mitsustyle.com/forums/showthread.php?t=26772

Image[/url]
YOU NEED SOMETHING FROM THE STATES
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

noice!!!

you'll have a bit of trouble being seen though, no?
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
C89ZX7R
[P] Plates
Posts: 36
Joined: Fri Jul 16, 2004 6:23 pm
Location: USA

Post by C89ZX7R »

thrash wrote:noice!!!

you'll have a bit of trouble being seen though, no?
Yea. friend tried to take a picture of it in the dark and it came out as a shadow. Couldnt see it.
YOU NEED SOMETHING FROM THE STATES
EVOMINUS
[P] Plater austaz
Posts: 28
Joined: Wed May 06, 2009 3:13 am
Location: GREECE,ATHENS
Contact:

Post by EVOMINUS »

what exactly you mean by "recycled"??????
C89ZX7R
[P] Plates
Posts: 36
Joined: Fri Jul 16, 2004 6:23 pm
Location: USA

Post by C89ZX7R »

EVOMINUS wrote:what exactly you mean by "recycled"??????
Sent to the crusher after blowing out the rings LOL.
YOU NEED SOMETHING FROM THE STATES
User avatar
1320ft
almost postwhore
Posts: 1071
Joined: Mon May 03, 2010 8:33 pm
Location: St Andrews NSW

Post by 1320ft »

Damn that looks hot!
The Forum Parts Guy

www.vibrantperformance.com for all your performance fabrication needs

IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car

Here to run out of your life & take all your money!
C89ZX7R
[P] Plates
Posts: 36
Joined: Fri Jul 16, 2004 6:23 pm
Location: USA

Post by C89ZX7R »

Was painted with a rattle can, same with the rims.
YOU NEED SOMETHING FROM THE STATES
FST4RD
almost postwhore
Posts: 1223
Joined: Sat Dec 09, 2006 10:22 am
Location: Christchurch

Post by FST4RD »

Does look good!
Sold - 1987 Mitsubishi Starion GSR V DASH
Current - 1995 Subaru Legacy TT SW
- 1983 Mitsubishi Starion
Mick
Enthusiast
Posts: 643
Joined: Sun Mar 12, 2006 1:37 pm
Location: Hobart, Tas

Post by Mick »

sad it got crushed looks brutal
FS: Ford 302ci Windsor. Race prepped block, Clevite bearings, ARP fixings, Hypertectic pistons, nitrided rods, knife edged crank, Gilmer drive, chrome moly rings, Yella Terra stage 3 heads, manly valves, Comp cams 294* solid roller, YT roller rockers, Funnelweb manifold, 2 inch spacer, Proform 830cfm carb, K&N 10" stack, ICE ignition. - 0437900210
EVOMINUS
[P] Plater austaz
Posts: 28
Joined: Wed May 06, 2009 3:13 am
Location: GREECE,ATHENS
Contact:

Post by EVOMINUS »

C89ZX7R wrote:
EVOMINUS wrote:what exactly you mean by "recycled"??????
Sent to the crusher after blowing out the rings LOL.
:cry: :cry: :cry: :cry:
C89ZX7R
[P] Plates
Posts: 36
Joined: Fri Jul 16, 2004 6:23 pm
Location: USA

Post by C89ZX7R »

Miss this car lol
YOU NEED SOMETHING FROM THE STATES
User avatar
niss720
Mine is bigger than yours
Posts: 277
Joined: Sun Apr 10, 2011 1:26 am
Location: Adelaide

Post by niss720 »

:( did you at least take the good bits off
Parting Blue JA Starion

Mercedes W126 420sel
Blue JA Starion (parting)
Silver JA Starion, 45000kms, coilovers
4G63 VR4 cordia
flav
Austarion Occupant
Posts: 3374
Joined: Thu Apr 15, 2004 9:57 pm
Location: Melbourne

Post by flav »

looks tuff!
Post Reply

Who is online

Users browsing this forum: No registered users and 41 guests