MR Benders new project:

Display your ride and post power figures, dyno runs, drag and circuit times.
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

isn't neg camber meant to be helpful on the front only though?

I like wide negative offset wheels too.. but i don't like the stretched tyres much.. much prefer straight vertical sidewalls
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
User avatar
1320ft
almost postwhore
Posts: 1071
Joined: Mon May 03, 2010 8:33 pm
Location: St Andrews NSW

Post by 1320ft »

Sorry, I cant dig the hella flush look.

Wide wheel & tyre packages, should look like this

Image
The Forum Parts Guy

www.vibrantperformance.com for all your performance fabrication needs

IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car

Here to run out of your life & take all your money!
dirtygalant
nearly postwhore
Posts: 1446
Joined: Sun Jun 19, 2005 7:27 pm
Location: Sunny Brisbane Australia!

Post by dirtygalant »

are you kidding me? that looks appalling.
ImageImage
E39A Galant VR-4 Evolution | A164A Eterna GSR | 6G72 RWD Conversion Forum
User avatar
MR Bender
Enthusiast king
Posts: 754
Joined: Sun Nov 11, 2007 8:01 pm
Location: Perth Western Australia (SOR)

Post by MR Bender »

As i said before the wheels where put on and the car was dumped just for that day!

also im not a huge fan of massive stretch eather but you cant find tyres to fit the rims good so i thought stuff it i will see how much stretch i can get.

and to tell you the truth it was almost more hassle than its was worth.

i got stuck on my driveway trying to get out,
i got stuck on a speed bump (got off it with planks of woods)
plowed the grass at the event

the car stood out
but couldnt drive it far or fast.

Even had to watch out for dips in the road!


anyway

WANTSOM I have replaced the rear pads and i need to book it in to set up the coilovers for racing, i have some underbody braces on order, and hoping to get a VR4 intercooler soon and plum it up , then a tune and fun!!!!!!!!!
Bite my shiny metal ass!!!

Russell Coight: Some of the animals are nocturnal, so the best time to see them is at night. Only you can't see them, because it's dark.
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

i actually happen to have a vr4 intercooler for sale.. *hint hint* :D
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

yeah don't like this either.. it's still form over function.. you wouldn't go drag racing with tyres as thin as those..
1320ft wrote:Sorry, I cant dig the hella flush look.

Wide wheel & tyre packages, should look like this

Image
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
dirtygalant
nearly postwhore
Posts: 1446
Joined: Sun Jun 19, 2005 7:27 pm
Location: Sunny Brisbane Australia!

Post by dirtygalant »

it looks like something straight out of a Hot 4s mag, I bet it's complete with tacky white or light tan vinyl re-trimmed interior and a million sub woofers everywhere.
ImageImage
E39A Galant VR-4 Evolution | A164A Eterna GSR | 6G72 RWD Conversion Forum
User avatar
1320ft
almost postwhore
Posts: 1071
Joined: Mon May 03, 2010 8:33 pm
Location: St Andrews NSW

Post by 1320ft »

dirtygalant wrote:it looks like something straight out of a Hot 4s mag, I bet it's complete with tacky white or light tan vinyl re-trimmed interior and a million sub woofers everywhere.
No, it actually made top 20 at Summernats.

It has JP Fab 3/4 chassis
4 link rear end
1200h/p Cosmo Block 20B Triple Rotor (By John Blanch)
GT47
R154 Box
Fabricated 9"
Smoothed Engine Bay
One piece sheet metal undercarriage


And Mamun, I wouldnt race with those tyres on either, but I can find the pic I have on Tristain Ockers, 7 sec blown capri, street car, driving in Thirlmere.
The Forum Parts Guy

www.vibrantperformance.com for all your performance fabrication needs

IRS OUTLAW, 2.3L VR4 Powered X235 Drag Car

Here to run out of your life & take all your money!
Komeuppance
Enthusiast
Posts: 607
Joined: Fri Nov 16, 2007 3:50 pm
Location: Oregon, USA
Contact:

Post by Komeuppance »

1320ft wrote:Sorry, I cant dig the hella flush look.

Wide wheel & tyre packages, should look like this

Image
Haha AUS spec!! I bet it's got a massive fully sikk intercooler on the front too... LOL...

-Robert
Image
Now: Australian Compatible!
User avatar
jwebb2876
I've been here before
Posts: 248
Joined: Wed Sep 03, 2008 10:53 am
Location: parkes

Post by jwebb2876 »

Too bad Sublime's an ugly hunk of shit. Well built and all, but it's still an autosalon-spec shitbox.

This is properly done wide, low offset and stretch, none of that hella-aids homosexuality:
Image
Image
And let's not forget Fonzy's TA22:
Image
Image
"Speed isn't everything; you gotta look cool on the touge too."- Keiichi Tsuchiya
gj2600.wordpress.com
dirtygalant
nearly postwhore
Posts: 1446
Joined: Sun Jun 19, 2005 7:27 pm
Location: Sunny Brisbane Australia!

Post by dirtygalant »

1320ft wrote:
dirtygalant wrote:it looks like something straight out of a Hot 4s mag, I bet it's complete with tacky white or light tan vinyl re-trimmed interior and a million sub woofers everywhere.
No, it actually made top 20 at Summernats.

It has JP Fab 3/4 chassis
4 link rear end
1200h/p Cosmo Block 20B Triple Rotor (By John Blanch)
GT47
R154 Box
Fabricated 9"
Smoothed Engine Bay
One piece sheet metal undercarriage


And Mamun, I wouldnt race with those tyres on either, but I can find the pic I have on Tristain Ockers, 7 sec blown capri, street car, driving in Thirlmere.
Who cares it looks ugly as fuck. It may be the fastest thing on the planet but I wouldn't be proud of owning it!
ImageImage
E39A Galant VR-4 Evolution | A164A Eterna GSR | 6G72 RWD Conversion Forum
dirtygalant
nearly postwhore
Posts: 1446
Joined: Sun Jun 19, 2005 7:27 pm
Location: Sunny Brisbane Australia!

Post by dirtygalant »

jwebb2876 wrote:Too bad Sublime's an ugly hunk of shit. Well built and all, but it's still an autosalon-spec shitbox.

This is properly done wide, low offset and stretch, none of that hella-aids homosexuality:
Image
Image
And let's not forget Fonzy's TA22:
Image
Image
I just had to quote this whole post to say..

YES
YES
YES and
FUCK YES!
ImageImage
E39A Galant VR-4 Evolution | A164A Eterna GSR | 6G72 RWD Conversion Forum
enthuzed
Austarion Occupant
Posts: 3578
Joined: Tue Apr 06, 2004 1:21 pm
Location: Melborno
Contact:

Post by enthuzed »

Whats the go with the Cressida - smoke stacks & handcuffs hanging out the back???
:wtf: I don't get that at all!

Each to their own... :roll:
Reduce fuel costs by 15-20% & cut emissions by 1/3rd...
Increase engine performance & prolong engine life...
How?
Click the website button below & watch the 3 minute video.
RiceThief
my mangina paid for my staz
Posts: 2129
Joined: Thu Jan 15, 2004 1:23 pm
Location: Brisbane

Post by RiceThief »

Its called bosozoku, the style originated from japan as a way to rebel against japanese mainstream society.
Starions are a disease, the only cure is poverty.

Project Grand Sport Racing Five
Mick
Enthusiast
Posts: 643
Joined: Sun Mar 12, 2006 1:37 pm
Location: Hobart, Tas

Post by Mick »

form over function?
bullshit its the other way round. im with aaron.
That silvia is a sick machine, change the colour or wheel style to anything you want but under the aesthetics its a good effort, if it had 16" simmons and was painted an old school colour you guys would be drooling over it.

they swap those 22's for a 31x12" slick and go racing, not only pose on the lawn.
the reason theyre tucked under is because its been mini tubbed, another function of having the need for fat rubber to get power down.
and at least he has suspension travel.

Why are there so many haters on this forum?
FS: Ford 302ci Windsor. Race prepped block, Clevite bearings, ARP fixings, Hypertectic pistons, nitrided rods, knife edged crank, Gilmer drive, chrome moly rings, Yella Terra stage 3 heads, manly valves, Comp cams 294* solid roller, YT roller rockers, Funnelweb manifold, 2 inch spacer, Proform 830cfm carb, K&N 10" stack, ICE ignition. - 0437900210
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests