Austarion

i thought this bar might look good on a a starion. what do you think? even just cutting th bottom part of it off so that it becomes an attachable airdam for the staz.?

anyone wanna try photochop it and see?



i thought about cutting off the lower part of the sentra bumper like this:


or wuld it just be easier to put the whole grille onto the starion?

once you chop it up to get the right angle and shape itll prolly be really filmsy and i dont see how your gonna mount it because once you chop it therell be no horozontal bits at the top to screw thru

i was going to fibreglass a lip on to the top of it.and put a steel brace in it too

Way too much fucking around... Leave that shit to the experts... It's different if you are a fiberglasser/bodybuilder...

Buy one of the existing lips avaliable they look good and are proven.

But if you want to have a go at it and it's cheap, then have a bash. It will mainly be just your time. You can only learn something if you fluck it up.

If the width is the same as a staz bar then you'll be one step ahead. If not you'll have to cut and shut to fit. If you're having a bash at fibreglassing, perhaps make a lower apron and graft the vents etc into it?

You will have to get different angles of the bodykit and be more specific on the photoshop. details. I done this at school I will try again w/ photoshop at home.