Page 1 of 1

CHUNKHEAD! Black interior paint?

Posted: Thu Jun 01, 2006 6:30 pm
by Glenjo
SIMON!!!!

What's that black interior paint you used to paint your door trims?

I want to get a set of JA top door trims, paint them black and cut into them for my split tweaters. Don't wanna go wrcking my JD trims.

cheers farker

:beer
Glenjo

Posted: Fri Jun 02, 2006 2:21 pm
by chunkhead
Ok Ok Ok!

Geez you can be impatient! :P

VHT Vinyl Dye, you can get it from Autobarn! I think one of the stickies is about this!? Anyway, make sure you clean the hell out of the trim with "Wax & Grease Remover" first! After that spray VERY light coats and allow about 1-2mins to dry between coats, continue till colour is even! Simple!

:beer :beer :beer

Posted: Sat Jun 03, 2006 9:05 am
by Mick
sorry to hijack this one :(

what do you reckon is the best paint to use on interior plastics ie door kicks, ecu kick panel, pillar cover...

cheers guys
mick

Posted: Sun Jun 04, 2006 1:48 pm
by chunkhead
Krylon Fusion!

You can only get in the States though! I used it on my centre console. It's chip and scratch proof. It also bends and streches, it's designed for plastics

Have since found it in a few places here that import it

http://www.birchhaby.com.au/

You can see some interior shots of my car in "Show & Go"

Posted: Sun Jun 04, 2006 2:17 pm
by Mick
thanks heaps chunk i sent them a message about it cos i'm in hobart and theres no outlets down here.

i'll check out your photos too!

Posted: Sun Jun 04, 2006 2:20 pm
by decoy

Posted: Sun Jun 04, 2006 2:32 pm
by Mick
thanks deeks you saved me an hour there :wtf:

VERY nice on the doors will definately do that.

getting some of the plastic paint could be a prob

Posted: Sun Jun 04, 2006 3:33 pm
by chunkhead
Yeah, I emailed them too! It's a nightmare trying to get it from the U.S! I'm going to spray my dash with it and the door sills (they're scratched to shithouse!) Seriously though, this stuff is bulletproof! My centre console gets full of shit, especially where the window controls are (grease and dirt from your fingers) just wipes clean with a wet cloth, never needs a polish or anything!

Doors are done with the VHT Vinyl Dye as stated above, make sure you get a trim tool to remove the trims though! Otherwise you WILL break clips! I got mine from Total Tools, cost about $5! :beer

Posted: Sun Jun 04, 2006 3:56 pm
by Mick
thanks for the pointers mate hopefully they'll get back to us about it. :x