Page 1 of 3
Carbon Fibre JA bonnet
Posted: Tue Nov 15, 2005 10:50 am
by WidebodyWoody
Posted: Tue Nov 15, 2005 12:49 pm
by gotrice?
:drool: :drool: :drool:
Whats the price?
Those looks wicked i'd be interested
Posted: Tue Nov 15, 2005 2:52 pm
by CussCuss
im not sure i have enough lube at home for the shipping, but dam that looks horny. If it was under 1k landed i might think about it, but i doubt it would be that cheap
Posted: Tue Nov 15, 2005 3:14 pm
by Flash
Depending on the price i may be interested.
Posted: Tue Nov 15, 2005 3:30 pm
by Alspos
Posted: Tue Nov 15, 2005 4:36 pm
by Cookiemonster
I'd be interested.
Posted: Tue Nov 15, 2005 9:56 pm
by CussCuss
definately interested at that price, infact with 2 people it would probably be enough to get the shipping 1/2 reasonable so pretty much in if theres another sydney person
Posted: Wed Nov 16, 2005 7:18 am
by toysrus
Yeah, guys, just hold up till they sort the glitches with the Scoop bit being flat. I know Carbon Fibre is strong how so realistic is it that it is bendable to fit perfectly ? or will they probably make another mould for that piece ?
The wieght saving is going on 6Kg which is the same as replacing that fat 15Kg Battery of yours with a nice 5Kg one
Posted: Wed Nov 16, 2005 1:44 pm
by WidebodyWoody
I was thinking more along the lines of US getting it made in AUS like they did, we get a bulk order, and then get a company to make it, might be able to pull it off cheaper.
Posted: Wed Nov 16, 2005 2:41 pm
by CussCuss
well these are chinese made, so wouldnt the shipping be comparable unless they are doing 20 in one hit and then distributing among the US
Posted: Wed Nov 16, 2005 3:57 pm
by Cookiemonster
Group buy - manufactured in Australia
or
Group import from overseas.
Either way is fine with me.
Posted: Wed Nov 16, 2005 4:02 pm
by fr335tyl3r
Also interested in this group buy. Need a new bonnet anyway, might as well fork out a bit more and get a nice CF one.
Posted: Wed Nov 16, 2005 4:06 pm
by 4g6beat
I'm in for this if it goes through :) would it be posible to get it without the front vent inserted/glued in as i'd have to make an opening on it anyway for a vent i've got waiting around. :) depends on price of course anything above 1k and i'd be out.
Posted: Wed Nov 16, 2005 5:13 pm
by NXTIME
I am in. I might speak to a guy who makes carbon spoilers/bodykits to get a locally made price comparison.
EDIT: CussCuss, if the US ones are made in China, perhaps we could go direct to the Chinese maker and have them sent here direct. Shouldn't be much of a price difference.
Posted: Wed Nov 16, 2005 7:12 pm
by Chris 83JA
Would it be possible to get them made all one piece (vents not seperate bits), or would that make the mould too complex?
