Austarion

hey guys, just scored a 3 pce wing (wooot)

just wondering on how i would mount it..
any ideas? tanks

If you car had a 3 piece from the factory it's very easy

Just slot the pieces in place and screw the nuts on.

However if you have a older model then it's not that easy

You can drill some of the holes on the fenders, but rear most mounting is made into the chassis. So that would require modifying the rear quarter or the wing parts. Or use high strength adhesive.

And last. the boot part, I guess the easiest way is to cut the mountings from the wing and stick it on with high strength adhesive.
The problem is your boot glass doesn't have the mounting holes in it required to mount it.

To fit a 3 piece spoiler in place of the rubber ducktail you will find that the centre section has some bolts that match the existing fixing holes thru the glass hatch+ polyeurthane adhesive.
The side sections will need to have the protruding fixings cut off and fixed in place with adhesive and taped to hold them till the adhesive sets.
That is the way the panel shop did my JB

I was wondering the same thing

I will be using my red ex hatch so that wont be a prob. Ill just change whole hatch over but any more ideas on the other two 'wing' bits? [ if its a gsr111 to begin with? ]

mine is an older model that comes standard with no wing,

the wing is aftermarket but i can tell fits snug..

it has holes drilled in it.

I might just use hi strength adhesieve and then put some polished nuts over the bolt holes...

any idea what grade of glue to use? iv heard not to use silicon

sweet all painted and mounted , used sikaflex. black stuff worked great,