Good bits for sale: Supra boxes, turbos, injectors

[Anthony]

Guys, i had this stuff up for sale last year, and decided to not strip the car and to just finish it off. Things have changed personally 4 me, so it is all going this time, no questions. Ill have some other stuff to put up, just cant think right now.

.Supra w55/58, dellow bellhousing, flywheel, 2300pound pressure plate, new 5-puk clutch plate, 2-piece tailshaft to suit standard scorpion diff, crossmember (everything needed to bolt into scorpion bar shifter) only travelled 50 k's since being installed. 900
.4g54 rebuilt motor with shotpeened standard rods, new pistons, bearings etc, rebuilt pajero head with the works.....Offers?
.TO4e/66, .70ar comp cover, .84ar rear, p-trim wheel, 20km's old 1000
.Sigma Turbo exhaust manifold with rebuilt external gate 250
.1xmagna head (needs recondition)
.2x efi manifolds, modified to suit rwd setup
.Crane hi-6ds ignition system 300
.delphi 890cc injectors, test fitted and started in car only, so practically brand new 480
.Set of unknown injectors, only know that they flowed enough to make 305rwhp 200
.2xvl turbo fuel pumps 60 each
.Surge tank, lift pump, unknown capacity 100
.Carter lift pump, brand new 80
.genuine sigma oil cooler, with sandwich plate 160
.2nd sandwich plate with oil cooler, unknown item, volvo perhaps, no fittings or lines 90
.Re-built to4 to suit efi setup (no carbon seal)..... 1.06 exhaust housing, skyline to3 compressor wheel/comp cover. Water and oil cooled, 0 km's. 500
.Hybrid style cooler, 450x300, with stainless piping to suit scorpion 250
.Smallish intercooler and piping, had enough flow for 300rwhp @ 14psi 200
.pair of 4x114.3 skyline 15" rims (widened to 8") with micky thompson slicks, unsure of condition of slicks as they have been outside under a tarp for nearly 12 months 300
.Autometer gauges (varying sizes and styles, water temp (electric), oil temp (mechanical), a/f ratio, 2x boost)

Most of the gear was put in the car, then it has sat out the front of the house until now. I changed my mind a few times about keeping the stuff, but ive grown up, am over modifying cars and need to sell the stuff as it is just sitting here taking up space.

Everything is located in Brisbane, and ill have all the prices up as soon as i can. my email is roz__85@hotmail.com, and any questions should be directed there and NOT via pm or replying in this thread.

[Anthony]

just added prices. Not too sure about the efi manifolds or the heads (heads are still on the motors). I think all of the prices i have put up are pretty cheap, so i dont want stupid offers. If you want a couple of the bigger items, i.e diff + gearbox i can do some sort of deal.

Also have a rebuilt motor, shot peened standard rods, mahle pistons etc etc, was running in the car for about 2 weeks (still in car), couldnt get the car running properly due to other issues. Can pull the motor down for inspection, currently has the pajero heads with the works on it. Will sell for cheap complete with head, assembled.

[iXNAY]

what size are the:
Autometer gauges (2x boost)

and what size is the standard starion hole?

regards
Ryan