Page 1 of 1

WTB: TC05 or TD05 6cm2 Turbine housing

Posted: Mon Nov 29, 2004 7:55 pm
by Glynn
hey guys, just after a TD05 or TC05 6cm2 Turbine housing in good nick. or does anyone know of another 6cm2 turbine housing that will fit (and function) onto the TD05 turbine and core?

cheers, Glynn

Posted: Tue Nov 30, 2004 8:43 am
by mrb1
I may have one. However in my opinion that's too small for a 2.0. Hey what am I saying I want to sell it :D
Is it for a Starion?

Posted: Tue Nov 30, 2004 5:20 pm
by Glynn
yeah it's for a staz, 6cm2 may be to small as a single but will possibly be just right as a twin :wink:

Posted: Tue Nov 30, 2004 5:29 pm
by SpidersWeb
I have a TD05-12 here, exhaust housing is a direct Starion bolt in (same as TC05-12A). Has wastegate attached etc.

Its a full turbo, has shaft play, ported wastegate, I paid $200, make an offer if you want it. Since I know of the shaft play now, I dont expect 200 of course, just whatever, make an offer.

Posted: Tue Nov 30, 2004 7:28 pm
by Glynn
cheers man but if it bolts-up to a starion exhaust manifold then it's a 8cm2 housing. thanks anyway

Posted: Tue Nov 30, 2004 7:38 pm
by SpidersWeb
Ok sweet as, how do I find out (curious now)? Its pretty damn small and identical to the TC05-12

and it has DUCM 060 printed on the on the back of the exhaust housing, and the Mitsi logos and part number etc on the front.

Shaft Play: ~2mm up and down, 0mm side to side
Blades: no damage
Spins: freely

Posted: Wed Dec 01, 2004 3:23 pm
by Glynn
oh, if it's got .060 on the turbine housing then yeah it should be a 6cm2 but if it is then it shouldn't bolt upto the 4g63, the bolt pattern will be the same (but smaller) and the outlet will still have the 3bolt pattern but again will be smaller. the 6cm2 housing came off the 1.6L cordia (although some models had the 8cm2) can you measure the ID ? and the distance between the bolts?

Posted: Wed Dec 01, 2004 4:15 pm
by SpidersWeb
TD05-12
Turbine housing entrance ID: 40mm
Turbing housing exit ID: 45mm
Distance between bolts - 4 bolt in: 55mm and 75mm
Distance between bolts - 3 bolt out: 75mm

and the output for the internal wastegate seems ported and polished by the look/feel of it. Wastegate actuator is one of them two stage models (high/low activated by thermostat). Looks like its watercooled.

Came off a Sigma GSR-X if that helps at all.

Compressor markings: Mitsi logo - TD05-12 - 4616 - 49168 01900 S
Turbine markings: Mitsi Logo - 13600 - then DUCM 060 on rear

Posted: Thu Dec 02, 2004 11:46 am
by Glynn
yeah man thats a 6cm2, i only need the turbine housing though