Austarion

Posted: **Wed Sep 29, 2004 1:39 pm**

Hi guys,

Looking for the following parts for some conversions that are being done within the next month. If you know of places to get them, please let me know.

- RX7/VR4/EVO2or3 injectors (500cc min)
- Bosch Fuel Pump (910)
- Front strut brace (prefer one that goes around back of rocker cover)
- 3 Bar map sensor *Have found retail for 156...any1 know of better one?*

Thanks :D

Posted: **Wed Sep 29, 2004 1:57 pm**

have a squiz at www.clubvr4.org they have plenty of evo and vr4 ones, much better than the rx7 jobs

Posted: **Wed Sep 29, 2004 11:43 pm**

Ok thanks man, ill have a look there for injectors.

Posted: **Wed Sep 29, 2004 11:50 pm**

CussCuss wrote: much better than the rx7 jobs

Why do you say that?

Posted: **Thu Sep 30, 2004 6:50 pm**

I'm likely to have a set of 4 springs for sale soon after I'm finshed installing the new springs I recently bought. So if you can wait a month or two (I'm going to be travelling for work, making the delay longer), I can PM you when they become available.

My ride height is about 320mm rear, 305mm front. That's wheel centre to guard lip.

Posted: **Thu Sep 30, 2004 7:59 pm**

I think i have found a set. but ill let you know if it falls through

Posted: **Thu Sep 30, 2004 9:41 pm**

Fuel wrote:
CussCuss wrote: much better than the rx7 jobs
Why do you say that?

i was told they have a shitty spray pattern

Posted: **Thu Sep 30, 2004 11:32 pm**

I have a rear strut brace - $100.

Posted: **Fri Oct 01, 2004 7:48 am**

i havr vr4 pistons / rods
also have some 600cc injectors..

pm if interested..

also have an o2 sensor.. from an evo

Posted: **Fri Oct 01, 2004 9:13 am**

Ok im still looking for the following bits and pieces. If anyone knows of a good place to get them that would be much appreciated:

Also, if you have any of the parts from this list or the top list send me a pm cause u may have a better part than the ones ive been offered:

VR4/RX7/Evo Injectors 500cc min
Bosch Fuel Pump (or similar to suit MPI upgrade)
Dual stage manual boost controller (must have switch)
2x Dual post 12v Coils
o2 sensor
L300 Optical Distributor
VN Commodore air intake (ill go to pick n payless if no1 here has 1)
2835 or 2530 turbo
Front strut brace
Vented rotors

Thanks guys
[/list]

Posted: **Fri Oct 01, 2004 1:13 pm**

Hi,

I have a set of Cross Drilled / Slotted front rotors if you are interested.

Email me at tjarvis@agl.com.au if you are interested.

Cheers
Troy

Posted: **Fri Oct 01, 2004 3:07 pm**

Are you still after an intercooler? Thinking about selling mine (88 Starion cooler)

Posted: **Fri Oct 01, 2004 3:47 pm**

Sorry hcca i found a cooler for the starion. Thanks for the offer though.

Posted: **Tue Oct 05, 2004 8:17 am**

*bump it up*

Posted: **Tue Oct 05, 2004 7:29 pm**

Bosch 910 fuel pump $195 new (trade should be cheaper). ASV in Villawood, NSW. I don't think it will be a problem fitting in the original location, but not 100% on that (can check its size for you) as I run mine externally.

Austarion

WTB: List of parts

WTB: List of parts

Vented Rotors