Austarion

The clear part on my headlight switches that show the decal underneath are all milky. The switches themselves are fine, just look a bit mank. Anyone for a decent set of the switch housings with clear plastic they'd part with?

I'm going to make new decals for underneath, so no worried if the decals look a bit stuffed, just has to have clear plastic.

I spent a bit of this evening trying to sand my ones down to get through the milkyness, but its all the way through, bugger it.

I think all mine are reasonable, but can check for you.
So you're saying Zac that you only want the green inserts that illuminate with backlighting?

Ive got some spares mate, il check the condition for you today

Sorry, I was a little un-clear.

I need just the plastic housing. The un-painted clear parts are all foggy in mine, and the plastic screw-bosses are snapped off inside (probably pretty common, I can probably fix those though).

The switches are fine in mine, and I'm going to make new illumination decals, but the plastic housings are stuffed :(.

The whole plastic housing is made out of clear plastic, and then painted black everywhere except where the decals have to show through so you can see what the buttons do.

Cheers Bryce, much appreciated. Ive got some bits for you too :).