Page 1 of 1
WANTED (VIC) - Roll Cage
Posted: Wed Aug 22, 2012 7:19 pm
by mteck
G'day guys,
Looking to get a bolt in roll cage made up for a JB Starion
Will be used for Drifting and must meet CAMS spec
Any advice would be super, Thanks
Posted: Wed Aug 22, 2012 7:47 pm
by 1320ft
Give this guy a call
Paul Broomfield on 0429 981 101 aka
www.mrparts.com.au
Or email him at
sales@mrparts.com.au
He has done heaps of cams & ANDRA cages, great work.
Just tell him your Aaron's mate for austarion
Posted: Wed Aug 22, 2012 8:01 pm
by mteck
THANK YOU
Posted: Thu Aug 23, 2012 8:58 am
by JJH
As stated in the Tech section post:
http://www.bondrollbars.com/
http://www.browndavis.com.au/motorsportcages.html
http://www.rollcages.com.au/ - I have a welded cage from these guys
Plenty of others around, go to CAMS web site or get a copy of the Motorsport Manual as most of the manufacturers have ads in it.
Posted: Thu Aug 23, 2012 2:40 pm
by starionc
Mtech did say Bolt in cage!
I'd check that a bolt in cage is still allowed before you spend any money mate!
My cage is a bonds welded in cage. They have all the measurements for a Starion, so you can order it over the phone. Mine was the first welded Starion cage they had done. (5 years ago now)
5 years from cage to dyno :( :( :( :( :x
Cheers
Jason
Posted: Thu Aug 23, 2012 10:31 pm
by thrash
yeah a bolt in cage or half cage that can be removed for street duties would be nice..
do all cages cut through the dash, or can you get one that is strong enough, but goes to the floor before the dash?
CAGE
Posted: Fri Aug 24, 2012 5:32 am
by 4gpwr