Austarion

Hi

Chasing both drivers and passenger front quarter panels as rust free as possible... (starting to think that might be dreaming to hard LOL ) In the Brisbane area would also be good.

These are for a JA but i would assume panels are pretty much interchangeable between JA/JB?


Cheers Dan.

are they just rusty down the bottom? or are they dodgy all over?

i might have found a source of replacement guard bottoms..

Theres a bottom part to the guards? rofl

I was thinking of going on a wreckers run to see if any thing was similar enough..

Are the bottoms your talking about made or along the lines i was already thinking of?

I believe sigma guard bottoms are identical, just not sure on early or late type, gotta find a sigma or two to compare..

You can get them off the shelf from certain suppliers.

Is that new off the shelf Dave? Would be handy in deed !!!!!

rare spares have got sigma and scorpion rust panels...

might check some out if i go to the office tomorrow

I have a spare vehicle that I store on a mates property. I know it has the drivers side panel, but I am unsure about rust and damage.

It's a 30 minute drive away tho, otherwise if it was closer I'd just go check and let you know right now. I am also in NSW, so It's not very close to drop it around to yours to have bahahaha!

I know it's only one, but It's an option if you get desperate :beer

starionc wrote:Is that new off the shelf Dave? Would be handy in deed !!!!!

yep i have bought many gemini guard bottoms before, one 180B guard bottom, and a sigma guard bottom many moons ago.. all brand new of course, most country wreckers used to keep them in stock..