Page 1 of 1
Distributor needed
Posted: Wed Jun 29, 2011 1:59 pm
by Vulpes
Help i need a dizzy, mine leaks like mad and the rpelacement i had on a parts car is the wrong one. I need the series two one with the lower cap. any help here ?
Posted: Wed Jun 29, 2011 4:47 pm
by 1320ft
I can try and get you a reco'd one.
But I need the numbers off the housing of the one that is leaking.
Posted: Fri Jul 01, 2011 2:13 pm
by Lunacy
Will a euro spec one fit it? From type 2 injection engine. Was working fine when removed. Pm me if interested
Posted: Fri Jul 01, 2011 7:07 pm
by John196701
Vulpes
I do have one out of my JB, was working before i changed to multi-point
Posted: Sat Jul 02, 2011 11:28 am
by MrBishi
Can't you just whack a new seal in?
Posted: Sat Jul 02, 2011 8:43 pm
by enthuzed
Or replace just the vac unit?
Posted: Sun Jul 03, 2011 6:44 pm
by Vulpes
$450 for a new seal and o-ring , a bit rich me thinks.
Posted: Mon Jul 04, 2011 2:03 pm
by MrBishi
Leaking oil out the shaft or vacuum leak?
Oil seal & O-ring should be gettable from any bearing shop for under $10 for both. Pull it apart and take the old seal down.
I'm not full bottle on the G63 distributors, but assume they can be disassembled without destroying bits?
Posted: Tue Jul 05, 2011 6:24 pm
by Vulpes
Its all good, John came to the rescue, thanks mate it is all back in and running great Cheers.