Austarion

Posted: **Sat Feb 12, 2011 1:31 pm**

For sale is a VR4 block prepared by Mick's Motorsport in Sydney.

It has stainless steel o-rings and has been precision bored to 86.5mm - with a 5 stage hone (the hone marks are still visible). The block has been line honed and it was acid cleaned. Block was also decked.

Comes with a copper head gasket (these are re-useable, you just anneal them prior to instaltion) and also a trial-fitted but never run Cometic head gasket.

Bare block with 2 gaskets and installed o-rings: $200

Located in Sale, Vic.

Posted: **Mon Feb 14, 2011 12:15 pm**

Damn you why can't you be in QLD. I would be on my way to get it right NOW :(

Posted: **Sun Feb 27, 2011 6:24 pm**

E-Go has excellent rates for freight!!

Surely I'm not asking too much for this?

I'm moving house in a month and would really prefer to not take this with me.

I can also throw in a sump - it has a few dents, but it's alright.

Posted: **Mon Feb 28, 2011 10:30 am**

I will go home pull out my pistons and see what size I have. Hopefully they will fit this block, if so, I will look into shipping costs and let you know tomorrow if I can use it :D

Posted: **Mon Feb 28, 2011 5:33 pm**

Awesome price, bad timing

Posted: **Tue Mar 01, 2011 9:46 am**

My pistons are 86mm. They are too small for this block I think...

Posted: **Sat May 07, 2011 7:02 pm**

This is still for sale.

I am also selling an as-new 85.5mm cometic head gasket, 60thou thick. Trial fitted, never run. $60 bargain.

Posted: **Mon May 09, 2011 2:04 pm**

Awesome price, wish it was a Starion block...

Posted: **Mon May 09, 2011 2:05 pm**

At 86.5, I don't know if a Starion block would have enough meat left!
This should sell pretty quick

Posted: **Wed Aug 10, 2011 9:07 pm**

Amazingly, this is still for sale.

I have enough paper weights at home, so please, grab this and build yourself a tough VR4 motor.

Posted: **Wed Aug 10, 2011 10:20 pm**

you have PM

Austarion

VR4 block, o-ringed...

VR4 block, o-ringed...