WTB: [VIC] Electronic Dizzy for MPI Setup
WTB: [VIC] Electronic Dizzy for MPI Setup
Anyone got an Electronic Dizzy, suitable for Starion 2ltr MPI upgrade, they want to move on?
Hoping someone can save me the searching/rummaging around exercise :D
PM me if you have something.
:beer
Hoping someone can save me the searching/rummaging around exercise :D
PM me if you have something.
:beer
-
- nearly postwhore
- Posts: 1446
- Joined: Sun Jun 19, 2005 7:27 pm
- Location: Sunny Brisbane Australia!
How common are HG/HH SOHC Galants over there? what about the early 90s SOHC Nimbus? Both should have the suitable optical dizzy.
E39A Galant VR-4 Evolution | A164A Eterna GSR | 6G72 RWD Conversion Forum
- perrinsohc
- Mine is bigger than yours
- Posts: 315
- Joined: Sat Mar 20, 2010 4:53 pm
- Location: Sydney/Christchurch
-
- nearly postwhore
- Posts: 1446
- Joined: Sun Jun 19, 2005 7:27 pm
- Location: Sunny Brisbane Australia!
well technically Starion dizzys are electronic with a hall effect sensor and ignition transistor module inside the distributor, it still retains the advancing weights and the vacuum advance/boost retard diaphragm - it works like you conventional dizzy. The optical distrubutors have no means of advancing or retarding the ignition, ie no weights and no vacuum/boost diaphragm attached. Inside, other than the rotor and shaft it has a disc with a certain number of slots and a optical pick up which then sends the information of exactly where abouts the engine is in crankshaft deg so the ECU knows which injectors to fire, and depending on the load of the engine the ECU can either advance or retard the ignition timing as it sends the signal to the coil to fire.
The DASH engines run the optical distributor, they also did away with the E101 knock control module - it seems the DASH ECU was quite a bit more advanced - pity they retained the horrible ECI setup.
The DASH engines run the optical distributor, they also did away with the E101 knock control module - it seems the DASH ECU was quite a bit more advanced - pity they retained the horrible ECI setup.
E39A Galant VR-4 Evolution | A164A Eterna GSR | 6G72 RWD Conversion Forum
DG you are a human encyclopedia on all things Mitsubishi :D :beerdirtygalant wrote:well technically Starion dizzys are electronic with a hall effect sensor and ignition transistor module inside the distributor, it still retains the advancing weights and the vacuum advance/boost retard diaphragm - it works like you conventional dizzy. The optical distrubutors have no means of advancing or retarding the ignition, ie no weights and no vacuum/boost diaphragm attached. Inside, other than the rotor and shaft it has a disc with a certain number of slots and a optical pick up which then sends the information of exactly where abouts the engine is in crankshaft deg so the ECU knows which injectors to fire, and depending on the load of the engine the ECU can either advance or retard the ignition timing as it sends the signal to the coil to fire.
The DASH engines run the optical distributor, they also did away with the E101 knock control module - it seems the DASH ECU was quite a bit more advanced - pity they retained the horrible ECI setup.
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
- perrinsohc
- Mine is bigger than yours
- Posts: 315
- Joined: Sat Mar 20, 2010 4:53 pm
- Location: Sydney/Christchurch
Awesome stuff, sounds like the way to go over a stardard staz dizzy if your doing mods like you want too. I'll have to do some reading up on all of this tech stuff. Thanks matedirtygalant wrote:well technically Starion dizzys are electronic with a hall effect sensor and ignition transistor module inside the distributor, it still retains the advancing weights and the vacuum advance/boost retard diaphragm - it works like you conventional dizzy. The optical distrubutors have no means of advancing or retarding the ignition, ie no weights and no vacuum/boost diaphragm attached. Inside, other than the rotor and shaft it has a disc with a certain number of slots and a optical pick up which then sends the information of exactly where abouts the engine is in crankshaft deg so the ECU knows which injectors to fire, and depending on the load of the engine the ECU can either advance or retard the ignition timing as it sends the signal to the coil to fire.
The DASH engines run the optical distributor, they also did away with the E101 knock control module - it seems the DASH ECU was quite a bit more advanced - pity they retained the horrible ECI setup.
87 Starion EX
-
- nearly postwhore
- Posts: 1446
- Joined: Sun Jun 19, 2005 7:27 pm
- Location: Sunny Brisbane Australia!
you'll need an aftermarket ECU in order to make use of the optical dizzy.
E39A Galant VR-4 Evolution | A164A Eterna GSR | 6G72 RWD Conversion Forum
Who is online
Users browsing this forum: No registered users and 37 guests