Page 1 of 2

F.S. Sydney Complete mpi motor

Posted: Fri Jun 18, 2010 1:35 pm
by www.18u
I got no room in my garage and i have no real use for it, so it's up for sale.

Engine is a 4g63 starion wideblock motor with the following.
VR4 Hypertec pistons.
ARP rod bolts
No shafts
4G64 head
Cometic Headgasket
L300 manifold with a custom plenum
AU Falcon throttle body
Custom T3 exhaust manifold made by Redzone
T3 turbo off a VL
560cc Evo injectors
Adjustable camgear
No ECU with motor

This motor made 169rwkw on 20 psi. It could have made more but it kept blowing intercooler pipes off, and the stock cam was close to its limit.
Motor has done less than 30,000kms since rebuild. It did have a few oil leaks, but since pulling the motor out i found the half moon seal leaking on the rocker cover, and the oil return hose from the turbo had a split in it. There was no leaks from any other areas so should be fine now.

Asking $1100 for the lot.
Image

Posted: Fri Jun 18, 2010 8:00 pm
by redzone
throw a KKR430 on that sucker and you'd be making over 200rwkw :wink:

good luck with the sale :)

Posted: Fri Jun 18, 2010 8:52 pm
by iXNAY
even a $300 ebay special would probably go pretty well on that also!

Posted: Sat Jun 19, 2010 12:32 am
by redzone
or an internal gate GT30 ;)

i've spammed a mate's fb page with a link to this, see if he pricks his ears up

Posted: Tue Jun 22, 2010 11:45 pm
by WANTSOM
This should go (ie sell) quick. Absolute bargain. Good luck with the sale Shannon.

ps- Maybe when you sell it I can get my engine trolley back that I see it is sitting on. Busted!!!! LOL -- just kidding, keep it mate, I have no use for it anymore and it would only add to the pile. :beer

Posted: Wed Jun 30, 2010 3:00 pm
by www.18u
Still here on my garage floor (ok on watsoms trolley ) but still here. this is nuts someone buy it...

Posted: Wed Jun 30, 2010 4:15 pm
by hoongirl
Still keen on the injectors :D

Posted: Wed Jul 07, 2010 3:19 pm
by www.18u
Bump. Thinking of splitting this up as there has been no interest at all.
Long motor $700 Manifolds $400 (includes turbo, but no injectors) plus shipping.

Posted: Wed Jul 07, 2010 7:13 pm
by leoca
hoongirl wrote:Still keen on the injectors :D
...can't you buy injectors WITHOUT engines attached to them???

Posted: Thu Jul 08, 2010 2:26 pm
by hoongirl
Yep. But I'm lazy & they're the ones I want :)
leoca wrote:
hoongirl wrote:Still keen on the injectors :D
...can't you buy injectors WITHOUT engines attached to them???

Posted: Sun Jul 11, 2010 5:07 pm
by www.18u
Motor is not for sale anymore. Inlet will be up for sale soon on its own however.

Posted: Sun Jul 11, 2010 10:18 pm
by TOMSUN
What's the motor going into?

Posted: Mon Jul 12, 2010 6:26 pm
by fugazi
TOMSUN wrote:What's the motor going into?
My bet's on the lawnmower... :D

Posted: Wed Jul 14, 2010 1:24 am
by www.18u
What's the motor going into?
I will give you a clue....... It's 2 door rofl

Posted: Wed Jul 14, 2010 5:07 am
by OLD FART
:wtf: Shannons transplanting it into Smart four two rofl