Austarion

hey people, six years on and the dream is still alive but its about to step up a level. im about to build my new motor and im looking for a few things

i have, full sonata multi setup with intercooler run by a microtech, ross forgies, new machined ported head, tdo6 20g


Block - previously unmachined to fit my pistons
CAM - non standard
injectors - 510cc etc
head gasket - what should i use? cometic what size etc

also i would like to know if anyone of you could recommend someone to make a custom exhaust manifold/dump in Melbourne

anything else you guys could recommend or would think is needed would be great

thank again
moz

bigmoz wrote:anything else you guys could recommend or would think is needed would be great

Twin cam head :D

iXNAY wrote: Twin cam :D

bitch

bigmoz wrote:

iXNAY wrote: Twin cam :D

bitch

i seriously dont see why you dont, you pretty much have enough stuff to go that way anyway...

you have injectors to get u going.
you have to make a custom manifold anyway.
you have a aftermarket ECU.
all you need is the twincam head+rear water outlet+inlet manifold or modified VR4 inlet.

have a block..its in my way, come get it