Austarion

For sale: 18 inch deep dish wheels to suit staz

Condition: used

Price and price conditions: 900 ono

Extra Info (ie mods/history etc etc):
18 inch wheels to suit a staz. I do apoloise, I am not sure what offset they are, but they are coming off a staz, so yeah. Not certain about the width either, but they are fairly wide - they have 235/45/18 tyres all round

Sale is for a set of 4.

Contact Details: pm me here, or message me on 0407482945

Location:
Sydney, NSW

Delivery & Conditions of Delivery: pickup - I suppose I can get them couriered, but i don't think it'd be cheap eh?


Reason for Selling: too big for my liking. I prefer smaller diameter but bigger dish :)

If they are off TomVR4

FRONT: 18x8.5 +29 with 25mm spacer = +4mm offset adjusted. 235 tyres.
REAR: 18x8.5 +29 with 8mm spacer? = +21 offset adjusted. 235 tyres.
Note: The front right just scrapes on the guard every now and again on full lock.

Great looking wheels!!!!!!!

thanks heaps for the info Pete! legend!

Here are some more pics of the wheels. http://forums.austarion.com/viewtopic.php?t=9355

Are you including the spacers in that price?

yeap, spacers will be included - this is assuming they are still on the car. But i didn't notice it scrub or anything, so i think they are still there :)

oh and yes, they are multistud - 4 stud and 5 stud :)

yeah the spacers are still there, it doesnt scrub cause the crash damage has pushed the front right gaurd out, haha. The scrubbing was never that bad though and it wouldn't have happened if the car wasnt so low (it was almost tuking the 14's). The spacers on the front are bolt on ones so I had to shorten the studs to suit, so if you are taking them off you will need new studs.

Message sent

more pics

These ones show the ding. The tyre still holds pressure fine - drove from lake macquarie to Sydney on these wheels.. that's over 100kms with no issues :)





The other wheels:







5c coin to show the amount of tread left - looks like it's 3-4mm. Same for All four of them

yeah, it balanced up fine and hold pressure fine. I never had any problems with it.

hey thanks Tom!

How's QLD treatin ya??