Austarion

Have had this tested by my auto sparkie May 09 and the output is as per specs and bearings are ok = no noise $60.00 + post

hey, do you have any pics. just wondering if this might fit my pajero? take one of the plugs

TomVR4 wrote:hey, do you have any pics. just wondering if this might fit my pajero? take one of the plugs

Tom Can send you pics on mobile if you give me your no
The space between the mounting where the long bolt goes thru is 53mm & the 2 male pins are like a 'T' EG- one horizontal with the other vertical below . The main thing is the spacing 4 the main bolt fixing to the block as the electrical plug is a simple fix if the 4by is different
Cheers
Rad

yeah the plugs are different, but i think that spacing is about right. How would I adapt up the plug, do you have a spare plug for this alternator? or maybe I could just cut the wires and fit some of those female spade type plugs on the wires.

TomVR4 wrote:yeah the plugs are different, but i think that spacing is about right. How would I adapt up the plug, do you have a spare plug for this alternator? or maybe I could just cut the wires and fit some of those female spade type plugs on the wires.

Insulated female spade connectors will be fine but you can get the appropriate connector fron any good auto sparkie It's up to you but either way will work perfectly :beer

yeah would be good to do it that way (the spade connectors) as then almost any alternator (4g54 and 63 maybe) would fit. it seems 4bn is hard on alternators and starter motors. (Ive been through 2 alternators and 1 starter). I am going to pack them full of grease next time.