Austarion

Seeing as the car is long gone the bodykit is up for sale.
Front is based on an R33 GTR and the original nosecone of the starion is actually moulded into the skirt for a good fit. (indicators not included).
The rear is based on a Jetspeed integra kit.
Both built out of fibreglass by FibreVision here in Perth, cost to manufacture was $3k.

For sale for $1.5k ono





need em gone as leaving the country at end of month. Pickup preferred as lack of lisence makes it hard to get to the post office.... :)

BUMP.. want to get rid of these to make room in the garage for something new... make any reasonable offers.. will send interstate if required.

FARK ! :o

Someone should get that front kit and make a few knock off's....
That is one good looking kit!

can the design be reproduced easily??.. i got too much money going elsewhere or i'd snap it up ... that kit is sh1t hot!!!

can people please stop flaming someone trying to sell something?

it may be ugly in your opinion but please dont just flame up this thread with useless trash talk this is the sort of stuff these forums dont need!

should be easy enough to make copies, just make a mould off it...

to previous comments: each to their own - if you don't like it STFU - I happen to like the design which is why I had them made in the first place, can't knock someone for liking something a little different.

still for sale - no longer have staz, want to get out of australia early next year - would be nice to make these dissapear - make an offer.. :)

If you will seperate, pm me your best price for the rear bar

hey mate how much would sell the front bar for??? and could you include postage in price if u are willing to sell separately..

cheers hayden...