Austarion

Now that my new stroker is in place ( thanks Dave ) i am considering rebuilding my original 282 hp atw bottom end and offering it 4 sale
the specs are
1 CRANK it was reground 're nitraded & balanced app 60k's ago
2 BLOCK will be honed and filled with either stock or forged VR4 pistons
3 RODS are stock rods that were beam polished , shotpeened & balanced & will be installed with new bearings
4 FLYWHEEL it has been lightened , balanced and has a app 60 k's old Direct Clutches heavy duty preasure plate & an organic driven plate
If there is anyone seriously interested and wanting to discuss price please PM or PH me 7an to 7pm
Rad 0409729177

expressioning my interest.. got a ball park $$ figure??

benny wrote:expressioning my interest.. got a ball park $$ figure??

You want forgies or not ???Forgies are app $600.00 more than stock vr4's

OLD FART wrote:

benny wrote:expressioning my interest.. got a ball park $$ figure??

You want forgies or not ???Forgies are app $600.00 more than stock vr4's

ok so i'm crawling back under my rock again now

I can get you a set of CP forgies with Eagle rods for a total of $1000 with ACL race bearings if your interested... Don't know how much that would put your price up oldie (not sure how much you are paying for VR4 pistons)

WidebodyWoody wrote:I can get you a set of CP forgies with Eagle rods for a total of $1000 with ACL race bearings if your interested... Don't know how much that would put your price up oldie (not sure how much you are paying for VR4 pistons)

That is a bargain...
I paid $990 for my CP forgies alone, plus $550 for eagle rods and about $200 for a ull set of king bearings!!!