Page 1 of 2
Garage cleanout
Posted: Fri May 23, 2008 6:34 pm
by 4gpwr
I am doing a garage cleanout mild steel 3 inch dump for a tco6 Starion exh housing $50 Original exhaust manifold no cracks $200 Adaptor flange for starion exhaust manifold to a t28 turbo cost a bit to make $150 Working order map sensor$100 Working order dash cluster $150 Pick up only
Posted: Fri May 23, 2008 10:13 pm
by Nosaki Faki
will it fit a factory US TD05?
Posted: Sat May 24, 2008 7:26 am
by Lunacy
Got a pic?
Posted: Sat May 24, 2008 1:16 pm
by 4gpwr
Nosaki Faki wrote:will it fit a factory US TD05?
TC and TD are a diffrent era of turbos
Posted: Sun May 25, 2008 8:32 pm
by Nosaki Faki
It appears to be the same as the TC05 that is on it now, it has 2 separate round flanges but the one for the wastegate is capped.
Is that how they are normally or is mine different?
Posted: Sun May 25, 2008 8:57 pm
by Nosaki Faki
Like this.
[/img]
dump
Posted: Mon May 26, 2008 9:29 am
by 4gpwr
I am sorry i cant transfer photos it looks like the right flange off the turbo but the center bolt is at the top of the three bolt flange cant say for sure
Posted: Mon May 26, 2008 12:23 pm
by redzone
yep the dump pipe SHOULD fit as the yank TD05 ex housings are same shape as our TC06's TC05's etc
dump
Posted: Mon May 26, 2008 3:25 pm
by 4gpwr
Just suspect the Flange is not on right angle
Posted: Tue May 27, 2008 9:33 pm
by Nosaki Faki
I will take it and give it a go if you're willing to chuck it in the mail?
I'm a fitter & turner so I can mod it easily enough if need be I just don't have access to all the gear I need to make my own nowadays.
Posted: Tue May 27, 2008 9:37 pm
by redzone
i just checked my widey and the 3 bolt flange has the top bolt right at the top..
Posted: Tue May 27, 2008 9:42 pm
by Nosaki Faki
so at worst I would need to cut and re-weld it.
Yes/No.
Dump
Posted: Thu May 29, 2008 4:44 pm
by 4gpwr
Nosaki Faki wrote:so at worst I would need to cut and re-weld it.
Yes/No.
Not going to post office for $50 next time you come to melb contact
Posted: Sat May 31, 2008 4:36 am
by flav
Yer, they bolt up differently...but mods can be done
Re: Dump
Posted: Sat May 31, 2008 5:22 pm
by 4gpwr
[quote="4gpwr"][quote="Nosaki Faki"]so at worst I would need to cut and re-weld it.
Cant cut the flange and reposition it because the 3 inch 90 deg pipe has been dinted to clear bolts