Hey guys
Having a massive clear out of any parts in my garage I haven't looked at in the last two years.
Will keep updating this list as I find more stuff.
Starion Stuff
Set of 4 pistons and rods - $20
Starter motor x 2 - $20 each
Fuel hard lines from tank to engine bay - $20 each.
Factory front sway bar - $20
Factory radiator and fans great condition - Sold to Firebrand
Tc05 non intercooler turbo. Bit of side to side play. Comes with a few used and unused turbo rebuild parts. May be able to make a gd one from it. $20
Tc06 compressor wheel and housing. Gd condition. $20
2 wastegate actuators - $10 each
CSA 17x8 mags with 4 good 215/45/17 tyres. 5 x 114.3 and +18 offset so good fit for 5 stud starions. $500
Shifter standard - $20
KM132 gearbox. No crunches and always ran beautifully. $350
New clutch throw out bearing - $20
Standard flywheel - $50
Standard fuel pump. One terminal half broken off but usable. - $20
Centre console trim that goes round shifter and radio. Grey. - $25
Oil feed line. Great condition. - $25
Bunch of strut tops, miscellaneous brackets, interior pieces etc - ask and I'll see if I have it.
Dohc 4g63t Stuff
Hydraulic tensioner (new) - $50
Vr4 rocker cover partially stripped of paint. $20
2 sets coil packs unknown condition. $20 each
Crank cam belt pulley $10
Crank. Std size but will probably need grind. $50
TD05h 7 cm exhaust housing. Wastegate flap welded up. $30
Evo/rvr front Cas sensor and mount plate. Poss have the cam disc too somewhere. $20
Plastic top cam gear cover. Silver. Gd condition. $20
Miscellaneous
Dytech stainless muffler 3" inlet 5" straight outlet. $50
Subaru Legacy bh5 flywheel. $50
Mig welding regulator for sodastream bottles. Plus 2 small and 2 large empty bottles that you exchange for full ones. $50
Simota pod filter. Dusty but unused $10
All parts are plus shipping from Auckland, NZ.
Garage Clean Out Updated 12th june
Garage Clean Out Updated 12th june
Last edited by Lunacy on Wed Jul 23, 2014 1:03 pm, edited 7 times in total.
-
- Woodwide
- Posts: 3133
- Joined: Thu Jan 08, 2004 6:24 pm
- Location: Gold Coast
- Contact:
No exhaust manifold sorry. Wil check shipping tomorrow shouldn't he much tho as I'm in Auckland.D_Loom wrote:Hey
Im interested in the TC05 Turbo. Is it still available to buy? How much would it cost to ship to Blenheim, NZ?
Also I was wondering if you had an exhaust manifold in good condition - if so how much do you want for it? Mines been repaired before and isnt in the best of condition.
Cheers Jason
I have a steam pipe T3 SP manifold for sale if you need it .all mating surfaces machined for a leak free seal. It is set up for a single 40mm gate.D_Loom wrote:Hey
Im interested in the TC05 Turbo. Is it still available to buy? How much would it cost to ship to Blenheim, NZ?
Also I was wondering if you had an exhaust manifold in good condition - if so how much do you want for it? Mines been repaired before and isnt in the best of condition.
Cheers Jason
I've had mine since 03 07 92
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
85 JB 2323cc DOHC 4G63
THE OLDER I GET THE FASTER I WAS
GROWING OLD IS MANDATORY GROWING UP IS OPTIONAL
Sorry man I've had a good look at it today and it's got a bit of side to side play in the shaft.D_Loom wrote:Thanks for the offer just trying to keep it original at the moment till I get it back on the road. When I upgrade the turbo Ive got someone local that can make me one.OLD FART wrote: I have a steam pipe T3 SP manifold for sale if you need it .all mating surfaces machined for a leak free seal. It is set up for a single 40mm gate.
Lunacy, i'm still interested in the tc05 turbo - have you found out how much it would cost to ship?
I wouldn't personally run it as is, so I've dropped the price to make it for parts/rebuild. If you still want it let me know.
Hey SamFirebrand wrote:I'd be keen on the radiator & fans (I assume electric?) if you can get them to Wellington at some stage..
also you don't happen to have a parcel tray or those plastic side panels where the speakers mount in the boot do you?
Yeah should be able to get the radiator down at some stage.
Sorry don't hav those interior bits
Who is online
Users browsing this forum: No registered users and 4 guests