FS: Early model factory intercooler and piping.

[ProZac]

Came with the red car, as I'm going to run it MPI, not really needed. It's unfortunately missing the last metal pipe which meets up to the intake, but would be possible to modify a non-intercooled one to work, or make one from scratch. a 2.5" silicone joiner is a very good fit on the early oval intakes. This is the early model setup that sits the intercooler flat behind the bumper, includes brackets.

After $150NZ for the setup, and I'd budget $60NZ to ship it to Aussieland, or $10 anywhere in NZ.

[JayME]

Could be keen for this - im guessing mine being non intercooled I would really need to change the compressor housing to get much benefit?

From memory the later tc06's looked a fair bit more open where the inlet pipe connects?

[ProZac]

Whoop, should have updated this thread, sold to aussie-land.

But yeah, you'd need an intercooled compressor housing and wastegate actuator. to make it all work, and some minor radiator support panel modifications.