Rear camber plates

OLD FART · Post by **OLD FART** » Thu Nov 22, 2012 8:48 am

Have heard pros/cons about the Mookeeh ones so where can I get them elsewhere :? :?

callan_rs2000 · Post by **callan_rs2000** » Thu Nov 22, 2012 10:19 am

i got mine out of the states from ebay

someone posted a link to them ages ago but they had sold out, i kept pestering them until they got more in stock

not sure if they're mookeeh ones or not but they are pretty good. they give you up to 4 degrees negative on the back which is a bit too much as i have found out at baskerville :?

enthuzed · Post by **enthuzed** » Fri Nov 23, 2012 7:41 am

I have a set of Mookeeh rear camber plates I doubt I'll use. If interested Rad, PM me.

OLD FART · Post by **OLD FART** » Fri Nov 23, 2012 7:53 am

enthuzed wrote:I have a set of Mookeeh rear camber plates I doubt I'll use. If interested Rad, PM me.

PM sent.
Am doing a training day with Stokel Motorsport at QR next Thursday and will be checking tyre temps with my laser tester across the width of the tyres to check/confirm if camber settings need to be adjusted.

panda · Post by **panda** » Mon Nov 26, 2012 11:42 am

Rad, there was once a suggestion that Dave RZ was going to fabricate some based on the Stebani system, but haven't heard if it happened.

Lummy · Post by **Lummy** » Mon Nov 26, 2012 5:20 pm

Old Fart,

Try to get hold of a pyrometer - it's a better indication of true tyre temps than just the surface-reading laser.

Bloody good tuning tool.

I've found that 2 degrees negative camber on the rear works pretty well.

Austarion

Rear camber plates

Rear camber plates

Who is online