WTB: Front Quarter Panels

[kailo]

Hi

Chasing both drivers and passenger front quarter panels as rust free as possible... (starting to think that might be dreaming to hard LOL ) In the Brisbane area would also be good.

These are for a JA but i would assume panels are pretty much interchangeable between JA/JB?


Cheers Dan.

[redzone]

are they just rusty down the bottom? or are they dodgy all over?

i might have found a source of replacement guard bottoms..

[kailo]

Theres a bottom part to the guards? rofl

I was thinking of going on a wreckers run to see if any thing was similar enough..

Are the bottoms your talking about made or along the lines i was already thinking of?

[redzone]

I believe sigma guard bottoms are identical, just not sure on early or late type, gotta find a sigma or two to compare..

You can get them off the shelf from certain suppliers.

[starionc]

Is that new off the shelf Dave? Would be handy in deed !!!!!

[kailo]

rare spares have got sigma and scorpion rust panels...

might check some out if i go to the office tomorrow

[Bruzman]

I have a spare vehicle that I store on a mates property. I know it has the drivers side panel, but I am unsure about rust and damage.

It's a 30 minute drive away tho, otherwise if it was closer I'd just go check and let you know right now. I am also in NSW, so It's not very close to drop it around to yours to have bahahaha!

I know it's only one, but It's an option if you get desperate :beer

[redzone]

Is that new off the shelf Dave? Would be handy in deed !!!!!

yep i have bought many gemini guard bottoms before, one 180B guard bottom, and a sigma guard bottom many moons ago.. all brand new of course, most country wreckers used to keep them in stock..