4G64 head with Crow cams double valve springs, Oversized stainless steel inlet and exhaust
valves with swirl polishing on the back of the valve heads, removed shotpeened and capped
jet valves, 4G63 manual rockers and has been cleaned up nicely, with a face of the head to
top it off. The whole lot copped a huge port job done by Flav, which cost $1200 alone. This
head will flow at least 500hp. The rockers, seats etc were cut/reconditioned and milled by
Headworx in Bunbury.
This has cost me over $2000, but i'd be willing to let it go for $1500 ono.
