dohc conversion 90 degree thermostat housings fs

airbats801 · Post by **airbats801** » Thu Oct 11, 2007 9:55 am

I currently have one in stock.

These are bolt on top portions of the thermostat housing that will route the rear water neck off a 4g63 dohc head parallel with the back of the head instead of pointing out into the firewall.

Taking paypal. 40 shipped via usps air

Here is a pic of what it would look like installed.
http://b18c5.org/eric/bmw/bmw101.jpg

Lunacy · Post by **Lunacy** » Thu Oct 11, 2007 12:02 pm

Price???

airbats801 · Post by **airbats801** » Thu Oct 11, 2007 4:10 pm

oops thought I put it up. Should be about 40 shipped. Unless I can get shipping a bit cheaper. I'm going to price ups tomorrow.

Lunacy · Post by **Lunacy** » Thu Oct 11, 2007 4:52 pm

Just out of interest what are these off? Been looking for one for awhile

airbats801 · Post by **airbats801** » Thu Oct 11, 2007 4:54 pm

usdm eclipse shit model. Go figure its off a saturn engine I believe.

BLOFLY · Post by **BLOFLY** » Thu Oct 11, 2007 6:10 pm

Will there need to be any massaging of the firewall to be able to use one of these?

airbats801 · Post by **airbats801** » Thu Oct 11, 2007 6:57 pm

I havent tried one personally, but from test fitting compared to a stock dohc one. The only massaging would be the main housing coming out of the head. Basically, instead of the water neck pointing out about 30 degrees, it runs straight along the back of the valve cover. So there is definately less banging needed, if any at all? I think you still need to bang a little for the cas?

www.18u · Post by **www.18u** » Fri Oct 12, 2007 5:43 pm

Sold to me :D

airbats801 · Post by **airbats801** » Tue Oct 16, 2007 5:01 pm

Currently have one for sale.

Austarion

dohc conversion 90 degree thermostat housings fs

dohc conversion 90 degree thermostat housings fs

Who is online