Complete 1985 GSR V Wrecking

[digitalsko]

I'd be after $80 NZD plus shipping for the lot, the front panel is suffering from the usual dents but I'd throw that in for free, they can be pressed out but the wind normally pushes them back in.

how much u think shipping would be??

[Junkers]

Hard call, $50? I'll ring around and see what I can find and pm you with the details.

It may make things much cheaper to source a front panel from aus?

[redzone]

anything over 110cm cannot be sent by post. and a front panel is about 140cm

[digitalsko]

bugger..... o well... ill just grab the clutch master and slave and the brake master cap please :D......
dave please tell me u have one lying around :D:D:D

[filiboy]

front bumper, mask, hood ??? prices :))))

[redzone]

yeah that car i was waiting on finally arrived mate

[Boner]

Hi,

I noticed your wrecking a 85 starion on Austarions forum buy/sell do you have a picture of the tail light and would you sell to Sydney Aust if they are the same as my JD tail-light. I also require a couple of other items such as the plastic covers that go over the tops of the rear seat belts, the mirror control switch that mounts in the centre of the console and the black alloy strip that runs across the top of the front windscreen.

Can you help ?

[enthuzed]

Boner, you might want to delete this post and then click on "New topic" & ask for what you want...You'll get much more help that way...

[enthuzed]

Btw, it's the little cross on the right hand side when you are looking at your post.

[Junkers]

Hi,

I noticed your wrecking a 85 starion on Austarions forum buy/sell do you have a picture of the tail light and would you sell to Sydney Aust if they are the same as my JD tail-light. I also require a couple of other items such as the plastic covers that go over the tops of the rear seat belts, the mirror control switch that mounts in the centre of the console and the black alloy strip that runs across the top of the front windscreen.

Can you help ?

Hi there boner, unfortunately I only have the black alloy strip. You would be better off sourcing those parts from Aussie.

Boner, you might want to delete this post and then click on "New topic" & ask for what you want...You'll get much more help that way...

I believe he was asking me a direct question, no need to try and push my sales away.

BTW he can't delete his posts after you've commented on them.

[enthuzed]

Sorry Junkers, my bad.

I thought I was reading a post from the technical area (I often read two or three simultanously) and thought he was posting a wanted.

And sorry Boner, clearly Junkers was trying to help you.