4G64 Cam Sprocket WTB

BLOFLY · Post by **BLOFLY** » Mon Sep 10, 2007 5:47 pm

Has anyone got one from a 2.4 sohc?

Starion VR4 · Post by **Starion VR4** » Mon Sep 10, 2007 6:46 pm

Yep.... same as 4G63 late model pressed steel units. How many U want? :beer

BLOFLY · Post by **BLOFLY** » Mon Sep 10, 2007 7:17 pm

Just the one should do it :D , btw did the late model change to the square tooth profile? as opposed to the starion round tooth. Is this correct?. Also what timing belt did you use for the 4G64 DOHC setup?

Starion VR4 · Post by **Starion VR4** » Tue Sep 11, 2007 8:19 am

U need to look at yr bottom pulley to make sure if its a SQUARE or ROUND TOOTH, that will determined what U need, but STD 4G64 had Round, as for belt...... 154X29RU is what U need, most Performance shops can get it, Do U have a DOHC Head for yr bottom end? :beer

BLOFLY · Post by **BLOFLY** » Wed Sep 19, 2007 9:11 am

Not yet. What cars would provide a dohc head that is suitable, also what inlet and exhaust manifolds are the best to use?

Austarion

4G64 Cam Sprocket WTB

4G64 Cam Sprocket WTB

Who is online