Austarion

Hey guys, i'm in the middle of a rebuild and it's time for new bearings.

I was wondering what you guys have used in the past and recommend etc? I was going to use ACL bearings but they can't get them to me for 4 weeks and i need them a bit earlier then that.

So any suggestions and opinions/prices etc on engine bearings would be great. It's for a dash engine.

Thanks guys..

try www.meek.com.au get in touch with chris he should have bearings in stock or at least point you in the right direction in sydney if you need them soon.

I used King bearings in mine

Ash

i use king`s in everything, try the listings 2 c if dash is same or not!

ACL and Mitsubishi are on par with each other apparently when it comes to the G63/4 B & 4G63/4 B due to the material ACL use in those particular bearings. I was recommened to stay away from Clevites from a Crankshaft re-conditioner who has been in the game for 30 years and does most of the old V8 race crank preps here in S.A.

I've heard about King Bearings but never asked........clearances are just as important as Bearing choice