Page 1 of 2
Strut Brace
Posted: Wed Mar 03, 2004 10:30 pm
by grumbly
Hey guys,
I'm currently making strut braces to suit Cordias.
These are using a hardened alloy bar and stainless steel end plates.
I was wondering if it was maybe worth making up some to suit Starions?
Cost would be around $160 - $170 MAX
I would also need access to a Starion in Adelaide to measure/ test etc.
Any interest?
(minimum number would apply)
Grumbly
Posted: Wed Mar 03, 2004 11:32 pm
by SCORP 1
what about for Scorpions? :D
re:
Posted: Thu Mar 04, 2004 2:28 am
by SIRIUS
yeh will be interested...i think a few people from over here will be interested as well...
Posted: Thu Mar 04, 2004 4:03 pm
by decoy
have you got a design planned? The last batch that were made wouldn't fit in my setup :(
Posted: Thu Mar 04, 2004 5:57 pm
by grumbly
no specific design as yet. will need to get a good look at a starion first.
will try to have it fit various engine types (cordia one fits all 3 major engines)
re:
Posted: Thu Mar 04, 2004 9:21 pm
by SIRIUS
what deeks is tryin to say is that the way he has his plumbing an mounted his BOV it ight get in the way of the brace...i think i might be in the same boat when thinkin about it...were abouts are you located...if u wana look at mine u can...
Posted: Thu Mar 04, 2004 10:09 pm
by grumbly
am in Blakeview.
PM me and we'll arrange a time etc. will be happy to do std and ones for, shall we say, awkward installs.
Posted: Fri Mar 05, 2004 12:44 am
by Rev
For that price, I would definately buy one.
Posted: Mon Mar 08, 2004 11:50 am
by dirty sanchez
Definately count me in! My previous strut brace wouldn't fit due to the intercooler plumbing so I sold it, but now with the SR20 fitted I need a strut brace again.
Posted: Mon Mar 08, 2004 12:48 pm
by AXELR8
No problem with my intercooler plumbing ( Get a twin cam boys!) :D . I would be EXTREEEEEEMLY interested in getting a brace! :drool:
Posted: Fri May 14, 2004 9:13 pm
by grumbly
these are for the cordias, starions would be similar...anyone actually interested?
Posted: Fri May 14, 2004 9:39 pm
by scum
me, can you do rear?
Posted: Fri May 14, 2004 11:18 pm
by SIRIUS
yeh that looks sweet...u know im in...
Posted: Sat May 15, 2004 2:27 pm
by tmz_99
Id be in assuming they were right with a twin cam engine.
Posted: Sat May 15, 2004 7:21 pm
by grumbly
ok then. I need to check some starions for measurements. Any engine config. would prefer one stock and a couple of modded ones, then I can get back to everyone with the details etc.
Adelaide only fellas....(for measurements anyway)