Page 1 of 9
STRUT BRACE ORDER INFO
Posted: Tue Jun 21, 2005 11:21 am
by grumbly
Cost will be $165 front and $160 rear. This includes Australia wide shipping.
Pre orders will attract a $20 discount if paid in full.
Front and rear together will be $300, pre order $280
Payments to:
David Bilney
PO Box 40
Ingle Farm SA 5098
or deposit to:
ACC: 22390821
Name: DA & TJ Bilney
BSB:805-022
Reference: your username.
email confirmation to
grumbly@adam.com.au
include username and delivery details.
All pre-payments before 21 July. This will enable me to order the bars asap and get delivery done hopefully end of July.
Cheers
Grumbly
Posted: Tue Jun 21, 2005 12:19 pm
by WidebodyWoody
How long does production of one take? A couple of hours?
Posted: Tue Jun 21, 2005 1:25 pm
by Fuel
Any pics?
Posted: Tue Jun 21, 2005 3:53 pm
by grumbly
pics of prototype coming.
production of one? no idea. I am making 15 sets at once.
JD
Posted: Tue Jun 21, 2005 7:07 pm
by JD_Stazza_Brendan
Will this fit on a JD???
Posted: Tue Jun 21, 2005 7:54 pm
by Starion_Turbo
should do I belive all starion shells were essentially the same, just check that it has a 3 bolt pattern on towers.
Posted: Tue Jun 21, 2005 8:04 pm
by JD_Stazza_Brendan
Starion_Turbo wrote:should do I belive all starion shells were essentially the same, just check that it has a 3 bolt pattern on towers.
I should have made myself clearer,,,
Will it clear the intercooler piping setup on the JD
Posted: Tue Jun 21, 2005 8:12 pm
by Starion_Turbo
does this piping sit higher than the throttle body??
we know it clears a vr4 conversion, but i dont think ive ever seen a factory set up JD intercooler and piping.
pics
Posted: Tue Jun 21, 2005 8:41 pm
by JD_Stazza_Brendan
Posted: Tue Jun 21, 2005 9:08 pm
by Starion_Turbo
yeah that should be fine it looks like it sits at the same hight of a standard crossover pipe and the first gen prototype bar cleared that, the test bar angled up slightly from the shock towers then leveled out.
Pictures of the prototype as fitted to a Starion would be a real asset in this department. . . . . . .
Posted: Tue Jun 21, 2005 9:19 pm
by grumbly
Drive up to Blakeview and I'll fit the prototype, front and rear and take pics.
easy eh? :D
Posted: Tue Jun 21, 2005 9:25 pm
by Starion_Turbo
just pm'd you about exactly that b4 I read this LOL
Posted: Tue Jun 21, 2005 10:39 pm
by mrb1
Will it fit over a L300 manifold?
Posted: Wed Jun 22, 2005 8:17 am
by Starion_Turbo
good question, i'm hoping to go and test fit one on my stock starion for photos and take a few measurments to post up for this kind of help.
Posted: Wed Jun 22, 2005 8:58 am
by WidebodyWoody
It should fit any standard starion, but I hope it still fits with the magna inlet. Otherwise I will have to make it fit
