Austarion

:D Tis only to work and try to get some work done on the staz while i'm there. Working in Concord ( Breakfast Point, i get to watch the tide go out so we can get some work done).I will want to take the car to a trustworthy shop. So if any of you Sydleans can help give me a call monday-0401378223 perty please. PS not bringing the goin out gear, trying to stay off the grog. :roll:

Steve,

Ring Ron at Coltspeed on 9807 3830. He's at Meadowbank. Not very far from Concord.

No one in Sydney will know more about Starions than him.

Cheers
Greg

Will do, bloody hard to stay of the grog when your staying at the pub. I shat my pants when the motel told me how mutch they wanted. :o :D

Steve, I still have a spare block and crank that are yours if you still need them. I don't mind hanging onto them until you need them, but are you still keen on having them?

Hows the car behaving? Have you transplanted to the good bits onto it?

That engine is just about dead , timing was about 20 deg, got me beat how it ran withuot complaing, coudnt even hear a crackle. Compression down on all 4 num 4the worst. Clutch stank like shit trying to get through Syd,had to ride it a tad to get her moving. Shit happens.

As for the parts yes. Just have to find the time and a way to get them.
I have been trying to swap things over but have not had time to scatch my bum yet. :roll:

I almost had the 12V thingies i was after but that did'nt work out . :beer

Bummer about that engine :( . It had a new head gasket put in about a month and half before too. Compression was never great, but it was about 120psi which I was told was average.

Let me know if I can help out with parts. If I got spares that will get you going, you can have 'em.