Page 1 of 1
roll centre adjusters
Posted: Sat Apr 10, 2010 2:45 pm
by S0LJAH
are these avaliable for starions anywhere?
looked at getting a set made up from an engineer but were pretty damn expensive
Posted: Sat Apr 10, 2010 4:10 pm
by Lunacy
Ye man mookeeh mk1 made them in the USA. Have a look on ebay for his shop pretty sure he's still selling them
Posted: Sat Apr 10, 2010 5:26 pm
by thrash
juice_2 is selling a pair..
for the noobs here (a.k.a me), what do this roll centre things do?
Posted: Sat Apr 10, 2010 10:22 pm
by jk
I purchased a set of the mookeeh RCA's and they are only 15mm. I plan on using 16x8 rims on my car, and I read somewhere on the US forum that this is about the tallest you could go with 16" rims due to the tie rod hitting the wheel. If you were planning to use larger diameter rims you would have the clearance to run taller RCA's, so you may want to investigate custom units anyway.
Thrash - RCA's are just spacers that fit between the bottom of the strut and the ball joint, they restore some of the lost steering/suspension geometry after lowering (depends on ride height change and spacer thickness).
Posted: Mon Apr 12, 2010 11:30 am
by TOMSUN
Are these them???
Posted: Mon Apr 12, 2010 11:40 am
by Nosaki Faki
yep thats the kids!
Posted: Tue Apr 13, 2010 3:07 pm
by panda
Posted: Tue Apr 13, 2010 4:07 pm
by S0LJAH
yea id say there juice_2 off heres
i have emailed him about them
Posted: Thu Apr 15, 2010 7:50 pm
by Komeuppance
TOMSUN wrote:
Are these them???
Damn that car is low...!!
-Robert