Austarion

seeing as we are posting lists, heres mine and the time scale:

body: (next 6-8 months)
panel and paint - 2 pearls
fitted widebody elec mirros, fited widebody numberplate garnish

engine:
DOHC conversion (6-8 months)
Prepped Camshaft
HKS Kansai Connecting Rods
HKS Forged Pistons
HKS Kansai Piston Rings
HKS 272 intake and exhaust camshafts w 9.7mm lift
Ported and poilshed cylinder head
Rallyart Cooler
Wolf 3d v4 (next month)
(below is like next 2 years sometime)
HKS 3075 turbo
HKS Super Mega Flow Intake
SX Pressure regulator
HKS Wastegate
HKS Super Sequential BOV

Brakes: (hopefully next 12 months or so)
R33 Brakes front and rear

Interior:
Custom Dash
Full leather retrim
Apexi RSM

ICE: (not a big rush - but slowly accumulating parts)
ditch current 2x12" and install 1x 15" in custom box
ditch current MB Quart splits for something else
install RF Power 500 amp to run sub
Maybe replace the head unit with something nicer

Driveline:

LSD

I expect that that engine combination SHOULD support 300+hp @ 1bar boost, the engine will be done in 2 stages, the internals should be done before the engine even goes in, then the turbo, etc, will be done afterwards. as soon as I get the engine bits together (4-5months) the car is booked in for a full panel and respray.

Ahh here it is.

Another thing I was going to mention, it might be ideal to put the race cams in AFTER the engine has worn in - since you want to keep the rpm low while everything settles in, might be a bit of an ass to drive with 272 cams. Looks like you'll be doing this anyway though :D

Should be awesome, and you've got a nice short time scale too :)

Scums list:

1x car that goes 'vroom'
1x lower trim for passanger door
1x can of coke
3x very pissed off hippos
1x straight jb rear bumper
1x 10,000 hours more labour
1x cattle prod (for the hippos)


tats about it.... i think.

Can I have a hippo too?

well if your handing out hippo's........ :D