Gaskets

nashstyle · Post by **nashstyle** » Mon Oct 18, 2004 3:39 pm

Anyone know where to buy gaskets from? In particular the throttle body base gasket? Apparently they were only made Genuine but I've called up heaps of Mitsu dealers any they have ceased production (typical). :roll:

Chris 83JA · Post by **Chris 83JA** » Mon Oct 18, 2004 4:34 pm

try going into one - i picked up an inlet manifold gasket from mitsu off maroondah hwy (just near you). That was for my l300 manifold, which was basically the same as the starion one.
I payed something like 25 bucks from mitsubishi, and later i found one at bursons for 10 bucks.
So yeah, try bursons or repco first :)

nashstyle · Post by **nashstyle** » Mon Oct 18, 2004 4:40 pm

That would be Eastside Mitsubishi, they dont even know what a Starion or Cordia is...
How long ago did you get it?

I'll give bursons/repco a shot aswell.

Chris 83JA · Post by **Chris 83JA** » Mon Oct 18, 2004 5:23 pm

get is probably not a good word.
I ordered it about a month ago, they said it'd be in by friday, friday came and it wasn't in, turned out to be damaged or something. I got a little angry and they said if i could find another one they'll refund my money. I found another one, but haven't been in to get my money back yet, have to find the receipt...

mrb1 · Post by **mrb1** » Mon Oct 18, 2004 7:21 pm

nashstyle wrote:That would be Eastside Mitsubishi, they dont even know what a Starion or Cordia is...
How long ago did you get it?

Tell them they used to sponsor Peter Fitzgerald's Starion in groupE!

Chris 83JA · Post by **Chris 83JA** » Wed Oct 20, 2004 2:02 pm

found this while browsing through ebay:
http://cgi.ebay.com.au/ws/eBayISAPI.dll ... eName=WDVW

not a tb gasket, but he may know where to get one from

nashstyle · Post by **nashstyle** » Wed Oct 20, 2004 2:29 pm

lol, thats my mate, he laso need a TB Gasket :P
I've found someone with an old but in-tact TB gasket and he said I can just trace it off him.

TD05 · Post by **TD05** » Fri Oct 22, 2004 7:45 pm

just make your own....

ProZac · Post by **ProZac** » Fri Oct 22, 2004 9:32 pm

definatly just make one, they're pretty easy.

Austarion

Gaskets

Gaskets

Who is online