Austarion

Would this fit innside the Starion diff housing ? http://www.arbusa.com/alac/215109.pdf Pajero 8" diff with 10 bolt ? would be nice with a strong locker :D

Not in a small JA or early JB housing (In Australia at least)

They are big enough for only a 7.25" drive gear, and suits a 25 spline shaft. It is a 10 bolt tho.

Sounds feasible with a JD centre but worth checking with someone who knows on that front...

anyone ??

hmm an arb airlocker hey? they're made in oz.. would possibly fit in a big diff, spose it depends on the spline count too as to which version of the diff u use....

So the best thing is to get a Pajero diff and try it out and if it fits buy air lockers :p

nah u need a starion big diff, the one with a smooth area around the drain plug not ribs, and u need to know which spline the diff uses, and match your starion half shafts to that type or make new splined ends for your half shafts

hmmm... So it will be an custom job then ? half shafts is drive shafts right ? Got the JD LSD diff so i think its the big type.. But aint it possible that it bolts right in ? Since the L300 diff bolt in..

well it might be a bolt in, u just need to count the number of splines on your drive shafts, and find out how many the arb has...

if they can supply u with all the dimensions then u will be able to find out.......

will be checking it out :) Why havent anybody tried this ?

And to somthing else.. Need right side tail light for my JD got one ? IMPOSSIBLE to find in Norway :(

It was asked about a long time ago....

http://forums.austarion.com/viewtopic.p ... ght=#66278

i'll have the US 6 bolt diff out of my JB soon, am planning on asking about it then. reason no one's done it here before is as has been stated, the big diff is the only one that may take it, and there are probably only around 100 of them in australia in total, and most dont wanna fk with them...


yep if u find a right side taillight let me know i need one too hahaha