ball bearing fell out?
Posted: Wed Jun 13, 2007 8:23 pm
hey guys just mounted my vr4 engine and narrowblock gearbox in my car and when i was finished i found a single ball bearing on the ground (about 5mm big)
i assume it has fallen out of the gearbox when i was putting engine and gbox in together, so had the gbox on a downward lean
anyone know where its from, and how i put it back in?
cheers
edit:i think maybe it fell out when we took the bolt/sender out for the reverse lights??
if so do i just pop it back in and do the sender up again?
anything i need to check is in the hole?
i assume it has fallen out of the gearbox when i was putting engine and gbox in together, so had the gbox on a downward lean
anyone know where its from, and how i put it back in?
cheers
edit:i think maybe it fell out when we took the bolt/sender out for the reverse lights??
if so do i just pop it back in and do the sender up again?
anything i need to check is in the hole?