ball bearing fell out?

[S0LJAH]

hey guys just mounted my vr4 engine and narrowblock gearbox in my car and when i was finished i found a single ball bearing on the ground (about 5mm big)
i assume it has fallen out of the gearbox when i was putting engine and gbox in together, so had the gbox on a downward lean

anyone know where its from, and how i put it back in?


cheers

edit:i think maybe it fell out when we took the bolt/sender out for the reverse lights??
if so do i just pop it back in and do the sender up again?

anything i need to check is in the hole?

[woops]

Yeah i'm pretty sure that it will be the ball bearing that goes in the reverse sensor hole. Without out it you will have no reverse lights due to the sensor being to short. Just pop it in the sensor hole and screw the reverse sensor back in.

[flav]

yep.........reverse.

[S0LJAH]

cheers guys

now i think about it it may have even come outtov the 4 speed i took out

we had to take the reverse sensor out to disconnect it
then wiggle the shit outtve the gbox

when i put the new box in the sensor was allready in it

il whip the sensor off and have a look if not ill pop it in


cheers