Page 1 of 1
how much torque has your 4g63 single cam got
Posted: Mon May 28, 2007 7:06 pm
by davidbek95
how much torque has your starion got with the single cam 4g63 got modified or standard motor if modified around 290 to 310hp got.
Posted: Tue May 29, 2007 3:49 am
by 2000_turbo
Modified; 243.1HP and 329Nmtorque.
That was a few years ago. I've got a 16V now.
Posted: Tue May 29, 2007 5:59 pm
by Chryzla
not nearly enough as my mouth
impressive
Posted: Tue May 29, 2007 6:30 pm
by davidbek95
very impressive for standard fuel injection set up
regards david
Posted: Tue May 29, 2007 6:35 pm
by Chryzla
2000_turbo, when moving the intake manifold around like you did... did you put the injectors back to the standard position? would have thought the fuel would be gravitating the wrong direction?
Posted: Tue May 29, 2007 7:07 pm
by RiceThief
When I first started modifying the starion 340nm with 103kw at the wheels.
Posted: Tue May 29, 2007 7:15 pm
by 2000_turbo
Chryzla wrote:2000_turbo, when moving the intake manifold around like you did... did you put the injectors back to the standard position? would have thought the fuel would be gravitating the wrong direction?
No, I just turned my ECI. We didn't believe that it would change the way the fuel is injected into the head. We didn't noticed any change the way the car drove exept for the HP of course! :D I've been driving for 5 years with this setup.
Gr,
Martijn.
Posted: Wed May 30, 2007 5:26 am
by OLD FART
My Dyno Dynamics power run shows 1540 lbs of tractive effort. Can someone do the math & convert it to kn
Posted: Wed May 30, 2007 4:17 pm
by dirtygalant
2000_turbo -> how did you rotate the ECI unit like that?
Posted: Wed May 30, 2007 7:32 pm
by 2000_turbo
We made a adapterplate. It's sitting between inlet manifold and ECI unit.
If you take a good look, you can see it in the picture.
Posted: Wed May 30, 2007 9:36 pm
by benny
sorry to continue the hijack but
specs for adaptor plate and a brief how to ( for re-routing the bits and pieces)
thx :D
Posted: Wed May 30, 2007 10:42 pm
by redzone
my orange car, 276hp at the wheels and 1200lbs of motive force :beer
Posted: Thu May 31, 2007 4:03 pm
by 2000_turbo
benny wrote:sorry to continue the hijack but
specs for adaptor plate and a brief how to ( for re-routing the bits and pieces)
thx :D
Sorry but, I haven't got specs for the adaptor plate. There is one thing that I can do, that is post a clear picture of the plate.
I'll post some pictures when I've got the time.
Gr,
Martijn.
Posted: Thu May 31, 2007 4:49 pm
by OLD FART
OLD FART wrote:My Dyno Dynamics power run shows 1540 lbs of tractive effort. Can someone do the math & convert it to kn
Toys have you done the math yet ??????????????????????????????
Posted: Thu May 31, 2007 10:46 pm
by toysrus
There's a couple topics on how to do so, on this very Forum, if you just search oh wise one.
:D
:D