Page 1 of 1
vr4 front brake setup
Posted: Wed Nov 15, 2006 12:10 am
by silo
Wonderin if anyone has looked at doin this?
My font cut came with twin piston brakes and front and rear TEIN coilover
suspension. Its still a mcpherson strut setup with the ball joint at the bottom
So i want to try and fit them! Any thoughts?
Posted: Wed Nov 15, 2006 5:37 am
by TWIMCAM BOY
give it a go mate you ll be surpised what will fit with a little customizing. i run s13 coilovers and 300zx brakes in my starion. GIVE IT A GO lets us know how you do with it.
Posted: Wed Nov 15, 2006 10:10 am
by AB
I have a feeling the lack of a driveshaft through the hub might cause some problems, but I wouldn't know for sure.
Posted: Wed Nov 15, 2006 10:53 am
by silo
Thanks guys :beer
Im gonna try pull of the strut assy today and size it up. AB you may
be right about the drive shaft, but Im prepared to give it a go anyway.
Replacement shocks and springs were going to cost about $1500, So
if i can modify these for less ill have better suspension, Bigger brakes,
And i may even try to carry over the steering rack too :D
I will try to take photos as i progress :beer
Posted: Wed Nov 15, 2006 7:07 pm
by Glen GSR III
TWIMCAM BOY wrote:give it a go mate you ll be surpised what will fit with a little customizing. i run s13 coilovers and 300zx brakes in my starion. GIVE IT A GO lets us know how you do with it.
Could i please get some pics and details mate? Ive got a set of ZX brakes here and nissan coilovers are piss easy to find. :beer
Posted: Wed Nov 15, 2006 8:10 pm
by TWIMCAM BOY
hey mate well give me a call 0408 992 232 my name is russell and ill fill you in zx brakes are not 100% finished but are close. BUT I CAN T GIVE ALL MY SECERTS AWAY! JKS give me a call and we ll have a chat
Posted: Wed Nov 15, 2006 8:21 pm
by Glen GSR III
will do mate, thanks :)