Austarion

not sure if this is the right area to post but anyway

i need a diagram or close up photo of the vacuum lines on a ja manifold cause mine go all over the place.

There was one posted on AUStarion by David a long time ago.

Being the nice bloke I am, I converted it to JPG and put it on my site for you:

http://www.starion.co.nz/ref/starion_vacmap.pdf

Also I like collecting this stuff, so if you guys have scans of books, or PDFs or a copy of that software Cam had, then let me know so I can host it, or give you a temp FTP account if its big.

EDIT: Cranked up Adobe Distiller, and made a 300dpi PDF as mentioned below. Its now only 43Kb, decent quality and easily printable

That file is a mile too big to print from windows. You will have to resize it to something more useful.

Its a JPEG not a PDF

If you want to print it, find a decent piece of software that will squeeze it in. Otherwise it'll loose to much quality to be usable (JPG is 72dpi, printers are 300dpi plus). Also its not hard to get a pen and sketch a copy.

Ill convert them to 300dpi PDFs at some stage, but for the moment the JPEGs will do for reference purposes.

EDIT: Converted to PDF anyway

Hi

I know this is an old thread, i have run a few searches but im after a vac line diagram for a JA starion 4g63 SOHC. I have just got the motor in, the stock engine seemed to have excess amount of vacuum lines and i suspect some have been added over the years as they are blanked off and go nowhere.

the below one is from cordia power, would any of this be similar.??