Austarion

Ok, took the alternator to the auto elect around the corner, said i needed a regulator, used one of his to see if it would work, said it would be 45 bucks, i said no thanks (knew it was too exxy) then went and got a replacement one today. Go to plug it in, but there is no spade(male prong) to hook the female connector onto. I feel like a dumbass but i cant work it out. Perhaps the auto elect has taken something needed to fit it? Note the new item is identical to the old one, dont know where the wire is supposed to go.

This:


Onto this somewhere? Anyone done it before?




Sorry about the pic quality, any help would be appreciated

looks like an earthing lead... you didnt notice what it was attached to before you pulled it apart?

i didnt pull it apart..lol...which is why i didnt know where it went. all good, worked it out, went and checked out another

why cant you put the terminal on the bit of the reg with two holes?