Parking Brake light always on...

[JDSTAZ45]

Has anyone had this issue before?
I played around with switch on the parking brake. I looks pretty basic with a spring and plastic centre and with an end tip as a contact to trigger it on.
Could this switch become faulty??? Or is there something else that is keeping it on in the wiring? Any clues?
Thanks in advance.

[popup]

I think the light is shared with the brake fluid low warning lamp. Check the connections on the master brake reservoir. Check its topped up and I think you must push the rubber cup in on the lid of the reservoir, otherwise it pushes the float switch down.

[JDSTAZ45]

^^^
Yes, Popup, you are right! It was a lowering of the brake fluid level. On the imported cars, there's one light on the dash which can mean
either Handbrake not properly released or low brake fluid level etc.
The Australian delivered cars have two separate light symbols on the dash, one as 'Park Brake'...for the lever and 'Brake' for the fluid level.
Just wish I had registered that in my brain before trying to find fault with the park lever switch and wires surrounding. A complete waste of a few hours.... :x
Anyway, all fixed now! :beer