Page 1 of 1

Can u identify this Intake manifold?

Posted: Thu Jun 17, 2004 9:20 am
by blackice
Ok, I'm at a loss here and can't find a damn thing about this intake. I need for vaccuum lines & wiring. It came with the DASH G63B engine from Japan, but uhh, Im hoping maybe someone has any ideas what car its from cuz dont look like a Cordia or Tredia one from what I've researched...and oh ya, only has 4 vacuum lines period off the block :/ Was hoping a starion or galant but u guys might know

Image
Blue is some unknown sensors. Top looks like the reg Coolant Temp Sensor, only 1 connector on it.
The bottom has 2, yes 2 sensors side by side right before the Thermostat housing. Both have 2 connectors on it. Forms a T.
U like the injector wiring job with the blue tape? :lol: They had all plugs chopped and I THINK its wired the right way finally.

Image
Red is circling the TPS sensor
Yellow is the 9 wire plug it uses
Car runs absolute crappy if TPS is plugged in so I'm thinkin I need the old Cordia 1.8 sensor or something

Someone plz help :(

Posted: Thu Jun 17, 2004 12:15 pm
by decoy
i recognise the dash tb, but not sure i've seen the ribbed rocker cover before? theres a couple of dash powered staz's on here i'm sure they might know how yours differs :?

Image

Dash inlet

Posted: Thu Jun 17, 2004 12:17 pm
by sirusdash
hey dude, i have full wiring diagram for this model (as I have 1 myself)
i can tell you what most things are on the inlet etc whats your email?

Posted: Thu Jun 17, 2004 5:17 pm
by toysrus
And a dash powered cordz here :oops:

Posted: Fri Jun 18, 2004 1:57 am
by blackice
I pm'd ya sirus. Thanks mate

Posted: Tue Jun 22, 2004 9:54 pm
by stariontron
both my dash rocker covers have ribbed tops :P